Britax P321900 manual Lower Universal Anchorage System Luas Installation

Page 20

Installation : Forward-Facing

Lower Universal Anchorage System (LUAS) Installation

• Figure A illustrates a typical

forward-facing

LUAS

 

 

installation.

 

 

 

• Verify that your vehicle is

equipped with

LUAS

 

 

anchors. If LUAS anchors are not available, you must

 

 

use vehicle belt installation methods.

 

 

 

WARNING!

 

 

A Forward-Facing

• This child seat must not be used forward-facing

 

for children less than one year of age OR who weigh

 

 

less than 9.1 kg (20 lbs).

 

 

 

This child seat must be in the upright position when

 

 

installed forward-facing.

 

 

 

Always use the Versa-Tether when the child seat is

 

 

installed forward-facing. Check your vehicle owner’s

 

manual for approved tether anchor locations.

b

 

1Remove the LCS connectors from storage slots under the cover. See page 29. Pull both LCS connectors completely through the child seat’s right-side, rear-facing belt slot (Fig. B) so they are

on the outside of the shell.

NOTE: The child seat is assembled with LCS

2Press and hold one LCS adjuster release button, C

then pull to extend LCS strap to full length. Repeat on the other end of the strap.

3Thread the appropriate LCS connector through forward-facing belt path (Fig. C) at the back of the child seat.

4Place the child seat sideways in the upright position on the vehicle seat with the back of the child seat facing you.

5Remove the Versa-Tether from the pouch and place it up and over the child seat back.connectors in rear-facing mode.

18

Image 20
Contents Diplomat Page Table of Contents Secure the top tether strap provided with this child seat Page Important Notes Certification RegistrationImportant Harness Adjustments Rear-FacingForward-Facing Child Seat Features 17 19 Vehicle Safety Belts Vehicle Buckle Positions Vehicle Seating PositionsLower Universal Anchorage System Luas Installation Rear-facing belt slot Fig. BIntended Lap-Shoulder Belt Installation Vehicle belt can be routed over or under the coverInstallation Rear-facing Lap-Belt Installation Intended Lower Universal Anchorage System Luas Installation Top Vehicle belt, then from the shoulder portion Fig. D Pouch. See pages 25 Lap-Belt Installation Installation Forward-Facing Aircraft Installation Safety Information Using the Versa-Tether Tether Connector Strap Switching the Lower Connector System LCS Verify that the harness is not twistedStoring the LCS Connectors Infant Body PillowChest Clip Harness BuckleHow to Adjust Harness Height Securing Your ChildChild Seat Functions Cover Removal Yoke on the rear of the child seat Fig. ERefitting the Cover Harness Buckle Removal Re-threading the Harness BuckleCleaning the Harness Buckle Warranty Double Check Car Seat-to-Vehicle Installation