Britax P321900 Lap-Shoulder Belt Installation, Vehicle belt can be routed over or under the cover

Installation : Rear-facing

Lap-Shoulder Belt Installation

•Figure A illustrates a typical rear-facing, lap-shoulder belt installation.

•When not in use, always store LCS connectors in storage slots. See page 29.

1Recline the child seat and place it rear-facing on the vehicle seat.

A Rear-Facing

WARNING! This child seat must be in the recline position when installed rear-facing. See

Recline Adjustment on page 29.

2Lift the child seat cover and open the rear-facing lock-off farthest from where the vehicle belt will b be buckled (Fig. B).

3Pull the vehicle belt out then pass it through the rear-facing belt slot (Fig. C).

•Vehicle belt can be routed over or under the cover.

4Route the vehicle belt across the child seat then through the opposite rear-facing belt slot.

•The vehicle belt must rest behind the child seat

	buckle strap.	C
5	Verify that the vehicle belt is not twisted, position
	the lap belt portion through the open lock-off,
	then buckle (Fig. D).
6	Push the child seat firmly into the vehicle seat
	while removing slack first from the lap portion of
	the vehicle belt, then from the shoulder portion
	(Fig. E).	D
7	Position the shoulder portion of the vehicle belt
	through the open lock-off, tighten belt, close the
	lock-off arm (Fig. F), and replace the child seat cover.

• The lock-off is properly closed when a positive click is heard.

14