Lap-Belt Installation

Installation : Forward-Facing

•Figure A illustrates a typical forward-facing, lap- belt installation.

•When not in use, always store the LCS connectors in the storage slots. See page 29.

WARNING!

•This child seat must NOT be used forward- facing for children less than one year of age OR who weigh less than 9.1 kg (20 lbs).

•This child seat must be in the upright position when installed forward-facing.

•Always use the Versa-Tether when the child seat is installed forward-facing. Check your vehicle owner’s manual for approved tether anchor locations.

1Place the child seat forward-facing on the vehicle seat. Ensure the bottom of the child seat base is in full contact with the vehicle seat.

2Remove the Versa-Tether from the pouch and place it up and over the child seat back.

3Pull the vehicle belt out, then pass it through the forward-facing belt path to the opposite side of the child seat (Fig. B).

A Forward-Facing

4Verify that the vehicle belt is not twisted, then buckle (Fig. C).

5Push the child seat firmly into vehicle seat while removing slack from the vehicle belt.

6Attach the Versa-Tether®hook to the designated tether anchor for the chosen seating position. Remove all the slack from the tether to secure. Store any excess webbing in the tether pouch. See pages 25 – 27.