Britax P321900 manual Lap-Belt Installation

Installation : Rear-facing

Lap-Belt Installation

•Figure A illustrates a typical rear-facing, lap-belt installation.

•When not in use, always store the LCS connectors in storage slots. See page 29.

1Recline the child seat and place it rear-facing on the vehicle seat.

A Rear-Facing

WARNING! This child seat must be in the recline position when installed rear-facing. See

Recline Adjustment on page 29.

2Lift the child seat cover and open the rear-facing lock-off farthest from where the vehicle belt will be buckled (Fig. B).

3Pull the vehicle belt out then pass it through the rear-facing belt slot (Fig. C).

•The vehicle belt can be routed over or under the child seat cover.

4Route the vehicle belt across the child seat then through the opposite rear-facing belt slot.

•The vehicle belt must rest behind the child seat buckle strap.

5Verify that the vehicle belt is not twisted, position the belt through the open lock-off, then buckle (Fig. D).

6Push the child seat firmly into the vehicle seat while removing the slack from the vehicle belt.

7Tighten the belt, close the lock-off arm (Fig. E) and replace the cover.

•The lock-off is properly closed when a positive click is heard.

b

C

D

16