Aiwa AV-X120 manual Precautions, Installation, Electric Power, Owner’s record, AC power cord

Page 2

Owner’s record

For your convenience, record the model number and serial number (you will find them on the rear of your unit) in the space provided below. Please refer to them when you contact your Aiwa dealer in case of difficulty.

Model No.

Serial No. (Lot No.)

AV-X120

{

PRECAUTIONS

Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for future reference. All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below.

Installation

1Water and moisture — Do not use this unit near water, such as near a bathtub, washbowl, swimming pool, or the like.

2Heat — Do not use this unit near heat sources, including heating vents, stoves, or other appliances that generate heat. It also should not be placed in temperatures less than 5°C (41‘F) or higher than 35°C (95”F).

3Mounting surface — Place the unit on a flat, even sutiace.

4Ventilation — The unit should be situated with adequate space around it so that proper heat ventilation is assured. Allow 10 cm (4 in.) clearance from the rear and the top of the unit, and 5 cm (2 in.) from each side.

-Do not place the unit on a bed, rug, or similar surface that may block the ventilation openings.

-Do not install the unit in a bookcase, cabinet, or airtight

rack where ventilation may be impeded.

5Objects and liquid entry —Take care that objects or liquids do not get inside the unit through the ventilation openings.

6Carts and stands — When- placed or mounted on a stand or cart, the unit should be moved with care.

Quick stops, excessive force, and uneven surfaces may cause the unit or cart to overturn or fall.

7Wall or ceiling mounting —The unit should not be mounted on a wall or ceiling, unless specified in the Operating Instructions.

Electric Power

1Power sources — Connect this unit only to power sources specified in the Operating Instructions, and as marked on the unit.

2Polarization — As a safety feature, some units are equipped with polarized AC power plugs which can only be inserted one way into a power outlet. If it is difficult or impossible to insert the AC power plug into an outlet, turn the plug over and try again. If it is not still inserted easily into the outlet, please call a qualified service technician to service or replace the outlet. To avoid defeating the safety feature of the

polarized plug, do not force it into a power outlet.

3AC power cord

-When disconnecting the AC power cord, pull it out by the AC power plug. Do not pull the cord itself.

-Never handle the AC power plug with wet hands, as this could result in fire or shock.

-Power cords should be firmly secured to avoid being severely bent, pinched, or walked upon. Pay particular attention to the cord from the unit to the power socket.

-Avoid overloading AC power plugs and extension cords beyond their capacity, as this could result in fire or shock.

4Extension cord — To help prevent electric shock, do not use a polarized AC power plug with an extension cord, receptacle, or other outlet unless the polarized plug can be completely inserted to prevent exposure of the blades of the plug.

1 ENGLISH

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Page Electric Power PrecautionsInstallation AC power cordTable of Contents Connections Connecting EquipmentBefore connecting the AC cord Connecting Speakers @ Positioning the SpeakersConnecting AN Outdoor Antenna Connecting the Supplied Antennas @Remote Control Setting the Clock Before OperationSound Adjustment During Recording Custom Audio AdjustmentVolume Control BBE SystemPress one of the DSP buttons DANCE, LIVE, Hall or Arena Electronic Graphic EqualizerDSP Surround Select the program source Selection of AUDIO/VIDEOSource Select the program source to be recordedPress the UPA or Downy button to select a station Tuning Direct TuningWhen an FM stereo broadcast contains noise To clear a preset station Presetting StationsPreset Number Tuning Repeat steps 1When selecting the Dolby PRO Logic mode in Im To Select a Dolby PRO Logic ModeRecommended mode Selecting Dolby PRO LogicTo change the sound levels after adjusting the balance Adjusting Speaker Level BalanceTo change the delay time About the channelsTo cancel the sleep timer Care and MaintenanceTo check the time remaining until the power is turned off To clean the cabinetAmplifier section FM tuner sectionAM tuner section GeneralGeneral Troubleshooting GuideParts Index Tuner SectionEneraia electrica PrecaucionesInstalacion Anotacion del propletarioMantenimiento IndiceAntena exterior Dailos we requieren re~aracionAntes de conectar el cable de alimentacion de CA ConexionesConexion DE Equipos 1111Conexion DE LOS Altavoces @ Ubicacion DE LOS AltavocesControlador Remoto Conexion DE LAS Antenas Suministradas @Conexion DE UNA Antena Exterior Seleccion del sistema de altavoces delanteros Antes DE LA OperacionPuesta EN Hora DEL Fieloj Presione el boton SETSistema BBE Control DEL VolumenAjuste DEL Sonido a SU Gusto Sistema Super T-BASSSonko Perimetrico DEL Para cancelar el modo seleccionadoEcualizador Grafico Electronic Pr’esione uno de Ios botones GEQ ecualizador graficoPonga en reproduction la fuente de programas seleccionada Seleccion DE UNA Fuente DEAUDIO/VIDEO Seleccione la fuente de programas que desee grabarSeleccionar una emisora Sintonia ManualSintonia Directa Repita Ios pasos 1 y Memorization DE EmisorasSintonia DE Emisoras POR SU Numero DE Memorization Para borrar una emisora memorizadaPRO Logic Seleccion DE Dolby PRO LogicPara Seleccionar UN MO130 Dolby faa~ Mantenga presionado el boton Dolby PROModo Dolby PRO Logic Phantom Ajuste DEL Equilibria DEL Nivel Entre AltavocesModo Dolby PRO Logic Normal O Wide Modo 3CH Logic Normal O WidePara cancelar el temporizador cronodesconectador Para Iimpiar el exteriorSeccion del sintonizador de AM EspecificacionesSeccion del sintonizador de FM Seccion Del amplificadorSeccion General Guia Para LA Solucion DE ProblemasIndice DE LAS Partes Seccion DEL SintonizadorFixation au mur ou au Dlafond L’amtii-tuner ne doit Das ElectricityReleve du proprietaira Sources d’alimentation Raccordez I’ampli-tunerEntretien Table DES MatieriesAntenne exterieure Reparations exiueant I’intervention d’un professionnelAvant de raccorder Ie cordon secteur RaccordementsRaccordement DE Tout ’EQUIPEMENT ArriereImpedance des enceintes Enceintes avant et arriere Raccordement DES ENCEINTES@Positionnement DES Enceintes Raccordement des bornee + a + et aRaccordement D’UN Antenne Exterieure Apropos DE LA TelecommandeRaccordement Desantennes Fournies @ Antenne FM Cadre MlReglage DE L’HORILOGE Tournez la commande Volume vers MINAvant DE Commencer Selection de la paire d’enceintes avantSysteme Super T-BASS Reglage DE VolumeReglage Personnel DU SON Systeme BBEEgaliseur Graphique Electronique Appuyez sw une des touches DSP IIDANCE, LiveSelectionnez la source de programme ’UNE SourceVideo Source Audio Demarrez la source de programme selectionnee Reglez Ie sonAccord Manuel Accord DirectRefaites Ies operations 1 et Prereglage DES StationsAccord DES Stations Prereglees Pour supprimer une station preregleeMode 3CH Logic Selectionnez ce mode si vous ne raccordez Pour Selectionner UN Mode Dolby PRO LogicMode Conseille Selection DU Dolby PRO LogicMode 3CH Logic Normal ou Wide Mode Dolby PRO Logic Normal ou WideMode Dolby PRO Logic Phantom Reglage DE LA Balance DU Niveau DES EnceintesPow arr&er la minuterie Reglage DE LA Minuterie ’ARRETPour verifier Ie temps restant jusqu’a la mise hors tension Pour nettoyer Ie coffret Utilisez un chiffon doux et secSection Tuner AM SpecificationsSection Tuner Section AmplificateurSection Tuner Le volume sonore est considerablement reduitEN CAS DE Panne Son emis par une enceinte seulementPage Page Aiwa CO.,LTII
Top Page Image Contents