Aiwa AV-X120 manual Connecting Speakers @, Positioning the Speakers

Page 5

CONNECTING SPEAKERS @)

Speaker terminals

Connect front speakers (system A and/or B), a center speaker and surround speakers to the corresponding speaker terminals on the unit:

-the front speaker cords to the FRONT SPEAKERS terminals

-the center speaker cord to the CENTER SPEAKER terminals

-the surround speaker cords to the SURROUND SPEAKERS terminals.

For more powerful bass, connect a sub woofer with a built-in amplifier to the SUPER WOOFER 4 jack.

Speaker impedance

●Front and center speakers

The SPEAKER IMPEDANCE SELECTOR on the rear should be set to the position that matches the impedance value of the front and center speakers.

When using 4 ohm speakers, set the selector to 4Q. When using 8 ohm speakers, set the selector to 8Q. Please unplug the AC cord before setting the selector.

●Surround speakers and super woofer

The SPEAKER IMPEDANCE SELECTOR has no effect on the SURROUND SPEAKERS terminals and the SUPER WOOFER Q jack. For the surround speakers and sub woofer, use speakers of 8 ohms or more.

Connecting + to +, - to - terminals

To get the proper sound effect, the speaker terminals on the unit and the speaker should be connected with proper polarity; the+ terminal on the unit should be connected to the + terminal on the speaker (and – to –).

m

*Be sure to connect the speaker cords correctly as shown in the illustration on the right column. Improper connections can cause short circuits in the SPEAKER(S) terminals.

*Do not leave objects generating magnetism near the speakers. ● When using a sub woofer, select the speaker system A (see

page 6). Otherwise no sound can be heard from it.

POSITIONING THE SPEAKERS

Position the speakers to make the most of the Dolby Pro Logic or DSP effect (see “DOLBYPRO LOGIC”).

@Front speakers

@Center speaker

Position in the center of the two front speakers. in addition, position on or below the TV set, if connecting a TV set to the unit.

@Surround speakers

Place the surround speakers directly to the side of or slightly behind the listening area. Align them horizontally, about 1 meter (3.2 feet) above ear height.

m

●Sound is heard from the surround speakers when the DSP is set to on.

●Sound is heard from the center speaker mainly when the Dolby Pro Logic is set to on. Note that when you select the PHANTOM mode of the Dolby Pro Logic, the center speaker is muted. (For details, see “DOLBYPRO LOGIC).

Front speakers

h

Lift up the terminal flap, inserf the speaker cord lead into the terminal slot, then close the flap. Check that the cord is connected securely.

Center speaker

\

-

——

.

 

 

Q

0

Sub woofer

Surround speakers

ENGLISH4

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Page Installation PrecautionsElectric Power AC power cordTable of Contents Connections Connecting EquipmentBefore connecting the AC cord Positioning the Speakers Connecting Speakers @Connecting AN Outdoor Antenna Connecting the Supplied Antennas @Remote Control Before Operation Setting the ClockVolume Control Custom Audio AdjustmentSound Adjustment During Recording BBE SystemPress one of the DSP buttons DANCE, LIVE, Hall or Arena Electronic Graphic EqualizerDSP Surround Source Selection of AUDIO/VIDEOSelect the program source Select the program source to be recordedPress the UPA or Downy button to select a station Tuning Direct TuningWhen an FM stereo broadcast contains noise Preset Number Tuning Presetting StationsTo clear a preset station Repeat steps 1Recommended mode To Select a Dolby PRO Logic ModeWhen selecting the Dolby PRO Logic mode in Im Selecting Dolby PRO LogicTo change the delay time Adjusting Speaker Level BalanceTo change the sound levels after adjusting the balance About the channelsTo check the time remaining until the power is turned off Care and MaintenanceTo cancel the sleep timer To clean the cabinetAM tuner section FM tuner sectionAmplifier section GeneralParts Index Troubleshooting GuideGeneral Tuner SectionInstalacion PrecaucionesEneraia electrica Anotacion del propletarioAntena exterior IndiceMantenimiento Dailos we requieren re~aracionConexion DE Equipos ConexionesAntes de conectar el cable de alimentacion de CA 1111Ubicacion DE LOS Altavoces Conexion DE LOS Altavoces @Controlador Remoto Conexion DE LAS Antenas Suministradas @Conexion DE UNA Antena Exterior Puesta EN Hora DEL Fieloj Antes DE LA OperacionSeleccion del sistema de altavoces delanteros Presione el boton SETAjuste DEL Sonido a SU Gusto Control DEL VolumenSistema BBE Sistema Super T-BASSEcualizador Grafico Electronic Para cancelar el modo seleccionadoSonko Perimetrico DEL Pr’esione uno de Ios botones GEQ ecualizador graficoAUDIO/VIDEO Seleccion DE UNA Fuente DEPonga en reproduction la fuente de programas seleccionada Seleccione la fuente de programas que desee grabarSeleccionar una emisora Sintonia ManualSintonia Directa Sintonia DE Emisoras POR SU Numero DE Memorization Memorization DE EmisorasRepita Ios pasos 1 y Para borrar una emisora memorizadaPara Seleccionar UN MO130 Dolby faa~ Seleccion DE Dolby PRO LogicPRO Logic Mantenga presionado el boton Dolby PROModo Dolby PRO Logic Normal O Wide Ajuste DEL Equilibria DEL Nivel Entre AltavocesModo Dolby PRO Logic Phantom Modo 3CH Logic Normal O WidePara Iimpiar el exterior Para cancelar el temporizador cronodesconectadorSeccion del sintonizador de FM EspecificacionesSeccion del sintonizador de AM Seccion Del amplificadorIndice DE LAS Partes Guia Para LA Solucion DE ProblemasSeccion General Seccion DEL SintonizadorReleve du proprietaira ElectricityFixation au mur ou au Dlafond L’amtii-tuner ne doit Das Sources d’alimentation Raccordez I’ampli-tunerAntenne exterieure Table DES MatieriesEntretien Reparations exiueant I’intervention d’un professionnelRaccordement DE Tout ’EQUIPEMENT RaccordementsAvant de raccorder Ie cordon secteur ArrierePositionnement DES Enceintes Raccordement DES ENCEINTES@Impedance des enceintes Enceintes avant et arriere Raccordement des bornee + a + et aRaccordement Desantennes Fournies @ Apropos DE LA TelecommandeRaccordement D’UN Antenne Exterieure Antenne FM Cadre MlAvant DE Commencer Tournez la commande Volume vers MINReglage DE L’HORILOGE Selection de la paire d’enceintes avantReglage Personnel DU SON Reglage DE VolumeSysteme Super T-BASS Systeme BBEAppuyez sw une des touches DSP IIDANCE, Live Egaliseur Graphique ElectroniqueVideo Source Audio ’UNE SourceSelectionnez la source de programme Demarrez la source de programme selectionnee Reglez Ie sonAccord Direct Accord ManuelAccord DES Stations Prereglees Prereglage DES StationsRefaites Ies operations 1 et Pour supprimer une station preregleeMode Conseille Pour Selectionner UN Mode Dolby PRO LogicMode 3CH Logic Selectionnez ce mode si vous ne raccordez Selection DU Dolby PRO LogicMode Dolby PRO Logic Phantom Mode Dolby PRO Logic Normal ou WideMode 3CH Logic Normal ou Wide Reglage DE LA Balance DU Niveau DES EnceintesPour verifier Ie temps restant jusqu’a la mise hors tension Reglage DE LA Minuterie ’ARRETPow arr&er la minuterie Pour nettoyer Ie coffret Utilisez un chiffon doux et secSection Tuner SpecificationsSection Tuner AM Section AmplificateurEN CAS DE Panne Le volume sonore est considerablement reduitSection Tuner Son emis par une enceinte seulementPage Page Aiwa CO.,LTII

AV-X120 specifications

The Aiwa AV-X120 is a versatile mini stereo system that epitomizes compact design and powerful performance. Engineered to cater to modern audio needs, it combines functionality with an array of features that make it a desirable choice for music enthusiasts.

One of the standout features of the AV-X120 is its high-quality sound output, achieved through the integration of advanced audio technologies. The system boasts a built-in digital amplifier that enhances audio clarity and ensures crisp sound quality across various genres. Additionally, the stereo system comes equipped with a pair of well-designed speakers that deliver rich bass and bright treble, ensuring a balanced listening experience.

The AV-X120 supports multiple playback sources, providing users with flexibility in how they enjoy their music. It includes a CD player that is compatible with various disc formats, allowing users to relive their favorite albums with ease. For those who prefer digital music, the system features Bluetooth connectivity, enabling wireless streaming from smartphones and tablets. This is complemented by USB and AUX inputs, which further expand the range of devices that can be connected.

The user-friendly interface of the Aiwa AV-X120 makes it easy to navigate through different modes and settings. It features an LCD display that provides clear information about the currently playing track and allows for seamless switching between different playback options. The remote control functionality adds an element of convenience, enabling users to adjust settings and manage playlists without having to get up.

A notable characteristic of the AV-X120 is its compact size, making it an ideal choice for smaller living spaces such as apartments or dorms. Despite its diminutive form factor, it does not compromise on sound quality or performance. The sleek design ensures that it can fit into various decor styles while providing a modern touch to any room.

In summary, the Aiwa AV-X120 is a well-rounded mini stereo system that appeals to diverse audio needs. With its powerful sound performance, compatibility with multiple playback sources, user-friendly interface, and stylish design, it presents an excellent option for anyone looking to elevate their music listening experience in a compact package. Whether you are hosting a gathering, relaxing at home, or simply enjoying some time to yourself, the AV-X120 is designed to meet and exceed expectations.
Top Page Image Contents