MANUAL |
| TUNING |
| DIRECT TUNING | |
|
| MONO |
|
| |
|
| TUNER |
|
| |
|
| * |
| Numbered | |
|
|
| 09QC2 | buttons | |
|
| 2 | C2C20C) | ||
POWER | 1 | Ill | |||
,00 |
1 Press the TUNER button repeatedly to select the
desired band.
Ffvf~ AM
1-1
When the TUNER button is pressed while the power is off, the power is turned on directly.
2 Press the UPA or DOWNY button to select a station.
Each time the button is pressed, the frequency changes. When a station is received, “TUNE” is displayed for two seconds. During FM stereo reception, ([[011) is displayed.
To search for a station quickly (Auto Search)
Keep the UPA or DOWNY button pressed until the tuner starts searching for a station. After tuning in to a station, the search stops.
To stop the Auto Search manually, press the UPA or DOWNT button,
●The Auto Search may not stop at stations with very weak signals.
When an FM stereo broadcast contains noise
Press the MONO TUNER button on the remote control so that “MONO appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button so that “MONO disappears.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Hold down the TUNER button and press the POWER button immediately. Note that the unit is set to the Direct Tuning mode if the TUNER button is pressed and held down for about two seconds.
To reset the interval, repeat this procedure.
When you know the frequency of the desired station, you can tune in directly to the station.
1 Press the TUNER button to select a band.
2 Press the TUNER button and hold it down until
3 Press the appropriate numbered buttons to tune in to the desired station.
Example:
To tune in to 106.50 MHz, press 1, 0, 6, 5 and O buttons. m To tune in to 95.2 MHz, press 9, 5, 2 and Q buttons.
To cancel the Direct tuning mode
Press the UPA or DOWNY button.
When using the remote control
Carry out steps 1 and 2 above, and press the numbered buttons on the remote control to tune in to the desirecl station.
●When entering a frequency out of tuning range, the value flashes for two seconds and then goes off. Check the frequency and repeat step 3 correctly.
●When entering a frequency not covered by the tuning interval, the value is automatically rounded up or down to the closest one covered by it.
ENGLISH 1 ~