Hardware Installation
4.Power on the PC and enter into DOS system.
5.Run the utility “Io-ir q.exe” contained in the driver diskette to set up I/O address, IRQ and INT vector of the board. Please refer to the next section, “IO-IRQ Utility and Hardware Configuration” for more details. Or follow the on-line help to configure the Industio CI-134 Series board.
After completing the hardware configuration, the board is ready for use under operating systems, such as Windows NT, 95/98, 3.x, DOS, etc.
IO-IRQ Utility and Hardware Configuration
Note that the CAP address, e.g. 0x180, is identical to the fir st por t's I/O addr ess except in one case that the JP1 jumper is installed before powering on the PC. In this case, the CAP address will be forced to 0xA700. The CAP address must be typed correctly. With the correct CAP address, the utility can find the configuration stored in the on-boar d EEPROM and display it on the configuration panel. The CAP address is the only channel via which the configuration utility Io-irq.exe can access the board.
1.Run the utility “Io-ir q.exe” contained in the driver diskette to set up I/O address, IRQ and INT vector of the board. Select “Smar tio/Industio ISA Family” and press ENTER in the following dialog box.
Industio CI-134 Series User’s Manual 2-5
