Rear Panel Connections | Citation Stereo Receiver specification

¡S-Video Main Output: Connect this jack to the main video display device that will be used to view the output of the source selected by the 5.0.

áS-Video Inputs: Connect the output of S-video sources to these input jacks. Once the inputs have been connected, they may be assigned to any of the 5.0’s program proﬁles using the Programs Setup Menu (see page 37).

Important Note on S-Video Sources: The 5.0 does not convert standard, composite video input signals into S-video outputs. In order for a video signal to appear at any of the S-video outputs, the input program must contain S-video source.

a Record A Composite Video Output: Connect this jack to the standard video “REC IN” jack of a VCR to record the input selected by the 5.0.

bAuxiliary Composite Video Output: This jack provides an additional composite video output connection for the source selected for the main viewing room.

cComposite Video Remote Zone Output: This jack provides a standard, composite video signal for the remote zone location. This input is selected by using the Remote Zone Input buttons R on the remote control.

dMain Composite Video Output: Connect this jack to the composite video input of the TV set, video monitor, projection television or other video display device that will be used in the main viewing location.

eComposite Video Inputs: Connect the output of composite video sources to these input jacks. Once the inputs have been connected, they may be assigned to any of the 5.0’s program proﬁles using the Programs Setup Menu (see page 37).

fOptical Digital Audio Inputs: Connect the optical (TosLink) digital audio output of audio sources to these jacks. Once the inputs have been connected, they may be assigned to any of the 5.0’s program proﬁles using the Programs Setup Menu (see page 37).

gCoax Digital Audio Inputs: Connect the coax digital audio output of audio sources to these jacks. Once the inputs have been connected, they may be assigned to any of the 5.0’s program proﬁles using the Programs Setup Menu (see page 37).