Citation Stereo Receiver owner manual Source Selection, Figure OSD-17

P O W E R O F F

S T A N D B Y

Figure OSD-17

POWER OFF

STANDBY

Figure FPD-3

If the 5.0 will not be used for an extended period (such as a vacation), you may wish to turn it off completely by pressing the Master Power button 1 in until it clicks, then releasing it to the extended position. The green Standby LED 6 will extinguish.

Source Selection

After turning the 5.0 on, select the video or audio source you wish to listen to by pressing either the

Úor Û Watch buttons 3 or the Ú or Û Watch selectors 4 on the front panel, or by pressing the Watch button • or the Listen button Ä on the remote control. While either will allow you to select the source of your choice, the two sets of buttons behave somewhat differently.

Using the front panel Watch or Listen buttons 3 4 produces a display on both video monitor (Figures OSD-18 or OSD-2) and the front panel (Figure FPD-2) which indicate the Program number selected, and relevant Program details, including source name, Surround mode and current volume setting. Pressing these buttons allows you to cycle through either the Listen or Watch programs, which may be the factory-set default programs (described on page 43 of this manual) or programs you have modified to suit your preferences as described in the “Program Setup” section of this manual starting on page 37.

	L I S T E N				W A T C H
P r o g 3	:	C D	a n a l o g	P r o g 1	:	L D a n a l o g
	6 Ð A x i s			P R O L O G I C
V o l u m e =			0 3	V o l u m e =			0 3
	Figure OSD-18				Figure OSD-2

Prog 7 : DVD

*Pro Logic* Vol=49

Figure FPD-2

Please note that the display on your video monitor (if it is turned on) will blank out after a few seconds, but that the information remains in the front panel display indefinitely, unless you press the Display button -, which will turn it off and on with each button press.

Operating the Citation 5.0

45