SPECTRA III
LANGUAGEENGLISH
<SYSTEM INFORMATION> <DISPLAY SETUP> <DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
EXIT
DOME SETTINGS
<CAMERA>
<MOTION> <POWER UP> <LINE SYNC> <PRESETS> <PATTERNS> <ZONES>
<TITLE TEXT> <ALERT>* <CLEAR> <PASSWORD>
BACK
EXIT
CAMERA
AUTO FOCUS | ON |
ZOOM LIMIT | X128 |
ZOOM SPEED | MEDIUM |
LOW LIGHT LIMIT | 2 |
|
|
<ADVANCED SETTINGS> |
|
BACK |
|
EXIT |
|
ADVANCED SETTINGS
SHUTTER SPEED | AUTO |
AGC LIMIT | 25 |
AUTO IRIS | AUTO |
AUTO IRIS LEVEL | 66 |
AUTO IRIS PEAK | 8 |
AUTO SHARPNESS | ON |
SHARPNESS LEVEL | 26 |
AUTO WHITE BALANCE | ON |
R GAIN | 482 |
B GAIN | 678 |
BACKLIGHT COMP | OFF |
VIDEO LEVEL | HIGH |
BACK |
|
EXIT |
|
*This setting only applies to Pressurized Spectra III dome systems with software version 1.25 or higher.
AUTO IRIS
Auto iris is the lens function that automatically opens and closes the iris in response to changing light conditions.
Program the auto iris to operate automatically or at a
OFF | Auto iris is disabled, and control is always manual. |
AUTO (default) | The iris is adjusted automatically to produce a constant video |
| output as determined by the Auto Iris Level setting. |
NOTE: If auto iris is in the auto mode, it will remain that way until the iris is manually opened or closed. The dome will return to auto mode when it is panned or tilted more than 15 degrees.
Auto Iris Level
Auto Iris Level is the numeric value the auto iris uses to maintain the brightness level of the camera. Increase the value to brighten the scene. Decrease the level to darken the scene. This setting can be adjusted if the video level in the auto iris mode is too bright or too dark.
NOTE: If backlight compensation is ON, decrease the Auto Iris Level setting.
Auto Iris Peak
Increasing the peak value will cause the auto iris circuit to react more to highlights or “peaks” in the picture. Decreasing this value will cause it to use the average video level to adjust the iris.
Quick Programming Guide
(See page 11)
19 |