Pelco DD53TC16-X Backlight Compensation Blc, Video Level, Quick Programming Guide, C2446M-E11/05

SPECTRA III

LANGUAGEENGLISH

<SYSTEM INFORMATION> <DISPLAY SETUP> <DOME SETTINGS>

ACK ALERT*

RESET CAMERA

CYCLE CAMERA POWER

REBOOT SYSTEM

EXIT

DOME SETTINGS

<CAMERA>

<MOTION> <POWER UP> <LINE SYNC> <PRESETS> <PATTERNS> <ZONES>

<TITLE TEXT> <ALERT>* <CLEAR> <PASSWORD>

BACK

EXIT

CAMERA

AUTO FOCUS	ON
ZOOM LIMIT	X128
ZOOM SPEED	MEDIUM
LOW LIGHT LIMIT	2
<ADVANCED SETTINGS>
BACK
EXIT

ADVANCED SETTINGS

SHUTTER SPEED	AUTO
AGC LIMIT	25
AUTO IRIS	AUTO
AUTO IRIS LEVEL	66
AUTO IRIS PEAK	8
AUTO SHARPNESS	ON
SHARPNESS LEVEL	26
AUTO WHITE BALANCE	ON
R GAIN	482
B GAIN	678
BACKLIGHT COMP	OFF
VIDEO LEVEL	HIGH
BACK
EXIT

*This setting only applies to Pressurized Spectra III dome systems with software version 1.25 or higher.

BACKLIGHT COMPENSATION (BLC)

If a bright backlight is present, the subjects in the picture may appear dark or as a silhouette. Backlight compensation enhances objects in the center of the picture. The dome uses the center of the picture to adjust the iris. If there is a bright light source outside of this area, it will wash out to white. The camera will adjust the iris so that the object in the sensitive area is properly exposed.

There are two backlight compensation settings:

ON	Backlight compensation is activated.
OFF (default)	Backlight compensation is not activated.

NOTE: If backlight compensation is ON, decrease the Auto Iris setting. Refer to the Auto Iris section.

VIDEO LEVEL

Set the video output to one of the following:

NORMAL	1.0 volt peak-to-peak
HIGH (default setting)	1.2 volt peak-to-peak to compensate for losses in video cable.

Quick Programming Guide

(See page 11)

C2446M-E (11/05) 21