Label Position
SPECTRA III
LANGUAGEENGLISH
<SYSTEM INFORMATION> <DISPLAY SETUP>
<DOME SETTINGS> ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
EXIT
DISPLAY SETUP
PRESET LABEL | 2 (SECS) |
ZONE LABEL | 2 (SECS) |
ZOOM | 2 (SECS) |
AZIMUTH/ELEVATION | 2 (SECS) |
DIRECTION | OFF |
ALARM MESSAGE | 2 (SECS) |
Labels can be placed anywhere on the monitor. This feature allows you to customize the appearance of your monitor screen.
The following labels are not set at fixed positions:
PRESET LABEL
ZONE LABEL
ZOOM RATIO - XXX.XX
AZIMUTH1/ELEVATION2 -
DIRECTION - NE
ALERT MESSAGE3*
TITLE TEXT
To set a label position:
1.Use the joystick to position the cursor beside a label.
2.Press Iris Open.
<LABEL POSITIONS> RESTORE FACTORY DEFAULTS
BACK
EXIT
3.Use the joystick to move the label up, down, left, and/or right.
4.Press Iris Open.
5.Repeat steps 1 through 4 to position other labels.
LABEL POSITION
[ZONE
[PRESET
[ALERT
[TITLE TEXT]
SAVE AND EXIT
CANCEL AND EXIT HELP
NE
XXX.XX
*This setting only applies to Pressurized Spectra III dome systems with software version 1.25 or higher.
6.Position the cursor next to Save and Exit. Press Iris Open to save settings and exit menu.
1Azimuth is the pan angle from 0° to 359°.
2Elevation is the tilt position from 0° (horizon) to
3The alert message is the warning displayed on the monitor if pressure, temperature, or dew point inside the dome reach unacceptable levels.
16 |