Pelco DD53TC16-X Accessing Main Menu Preset, CM6700/CM6800, KBD200A/KBD300A Direct Mode Only

Accessing Main Menu (Preset 95)

You can call up the main menu on your monitor by programming (setting or creating) preset 95 (preset 28 if in AD32-preset mode).

Programming preset 95 for Pelco’s controllers varies according to the type of controller you are using. Instructions for programming preset 95 are given below for various Pelco controllers.

CM6700/CM6800

1.Enter the number of the Spectra dome system and press the CAM key.

2.Enter 95 and hold the PRESET key for two seconds.

3.In the Edit Preset menu, arrow to SET and press the ACK key. The main menu appears.

KBD200A/KBD300A (Direct Mode Only)

1.Enter 95.

2.Hold the PRESET key (approximately five seconds) until the main menu appears on the screen.

CM9500

1.Enter the number of the Spectra dome system and press the CAM key. The Main menu appears.

2.Highlight SETUP in the Main menu and press the SELECT key.

3.Highlight CAM in the Setup menu and press the SELECT key.

4.Highlight PRESET in the Camera menu and press the SELECT key.

5.Enter 95 and press the F1 key. The main menu appears.

CM9740/CM9760/CM9770/CM9780

1.Press the ESCAPE key to open the Main menu. Select DEF. The Define Submenu appears.

2.Enter your four-digit PIN if this is your first time entering this mode.

3.Enter 95 and select PRST. The main menu appears on the monitor.

4.Select the Quit icon to return to the default menu.

(Continued on next page)

C2446M-E (11/05) 9