Pelco 9770 manual Color System, Port 1 RS-422 Baud Rate, Data Protection, Test Mode, Video Loss

The monitor output card DIP switch selects various options. These switches are set in the proper position at the factory, but they can be changed, if necessary.

		Table J. Monitor Output Card DIP Switch
Switch 1		Color System
ON		PAL
OFF		NTSC
Switch 3	Switch 2	Port 1 RS-422 Baud Rate
OFF	OFF	9600
ON	OFF	19200*
OFF	ON	57600
ON	ON	115200
Switch 4		Data Protection
ON		Main flash programmable
OFF		Main flash protected*
Switch 5	Switch 6	Test Mode
OFF	OFF	Not used*
ON	OFF	Diagnostic mode
OFF	ON	Display software version levels
ON	ON	Display color bars
		NOTE: You can also display color bars with a keyboard command (refer to Monitor Color Adjustment in the System
		Start-Upsection).
Switch 7		Video Loss
ON		Report
OFF		Ignore*
Switch 8		Primary VMC Program All Hardware
ON		Force
OFF		Upload if necessary*
		The primary CM9770-VMC card verifies the version levels on all software and hardware image binary files on the
		secondary CM9770-VMC card and the CM9770-VCC cards. If the file versions levels are not the same as the files on
		the primary CM9770-VMC, the primary CM9770-VMC updates all the files on the secondary CM9770-VMC card and
		the CM9770-VCC cards.
		If you change this setting to Force, the primary CM9770-VMC updates all the files on the secondary CM9770-VMC
		card and the CM9770-VCC cards without checking file version levels.
*Factory settings

50 C1555M-G (12/07)