JAI operation manual 3 RS-232 Cables and Connectors TM-6710 only, CS-232-B912

Page 8

Installation

If you are building your own power cables, consult the pin-out for the camera purchased. Connect the Ground and +12V power leads of the PC-12P power connector to Pin #1 and Pin #2, respectively. Remember that power must be DC regulated, and of sufficient current to properly power the camera.

Attach the power cable to the connector. The 12-pin connector is keyed and will only fit in one orientation. Rotate the connector while applying slight pressure until the keyways line up. Press the connector into place until it is firmly seated.

You may now plug the power cord into the 110V AC socket and power up the camera.

2.2.3RS-232 Cables and Connectors (TM-6710 only)

FIGURE 7. RS-232 Serial Communication Cable

MALE

	1	9
2	10		8

3 11 12 7

4 5 6

2000 ± 20mm

To: Power &
Sync Box			To: Camera
			FEMALE
	Part # CS-232-B912
12-Pin Male Connector		12-Pin Female Connector
Pin#	Description	Pin#	Description
1	GND	1	GND
2	+12V	2	+12V
3	GND	3	GND
4	Video Out	4	Video Out
5	GND	5	GND
6	VINIT	6	VINIT
7	VD In	7	VD In
8	N/C	8	N/C
9	HD In	9	HD In
10	N/C	10	RXD
11	INTEG	11	INTEG
12	N/C	12	TXD

To: Computer Com Port

1

5

6

9

TM-6710/6710CL High-Speed Progressive Scanning CCD Camera