JAI TM-6710 operation manual 1 c 51-Pin Connector, Camera Link Connector

Page 12

Page 6

Installation

2.2.1 (c) 51-Pin Connector

The TM-6710 has a 51-pin connector for RS-644 digital output (using B channel digital output to configure single channel).

FIGURE 3. 51-Pin Connector

18

1

35

19

51				36

Pin#		Description	Pin#	Description	Pin#	Description

1		A0+	18	CLK+	35	CLK-
2		B0+	19	A0-	36	GND
3		A1+	20	B0-	37	VCC (jumper)
4		B1+	21	A1-	38	VCC (jumper)
5		A2+	22	B1-	39	EXT. HD
6		B2+	23	A2-	40	TXD
7		A3+	24	B2-	41	LPULSE
8		B3+	25	A3-	42	RXD
9		A4+	26	B3-	43	VINIT
10		B4+	27	A4-	44	INTEG
11		A5+	28	B4-	45	EXP-
12		B5+	29	A5-	46	EXP+
13		A6+	30	B5-	47	LDV-
14		B6+	31	A6-	48	LDV+
15		A7+	32	B6-	49	FDV-
16		B7+	33	A7-	50	FDV+
17		GND	34	B7-	51	GND

2.2.1 (d) Camera Link Connector

The TM-6710CL has a 26-pin connector on the rear panel to output Camera Link data. The connector pinout is shown in Figure 4 below.

FIGURE 4. Camera Link Connector

13													1

13		12	11	10	9	8	7	6	5	4	3	2	1
26		25	24	23	22	21	20	19	18	17	16	15	14

2614

TM-6710/6710CL High-Speed Progressive Scanning CCD Camera

Image 12

Contents TM-6710/6710CL High-Speed Progressive Scanning CCD Camera Page Warranty CertificationsCE Compliance TM-6710/6710CL High-Speed Progressive Scanning CCD CameraPage Installation Ii Table of ContentsIii List of Figures Features IntroductionProduct Description Introduction ApplicationsIntroduction System Configuration TM-6710 System ConfigurationInstallation InstallationAccessories and Options Getting Started Unpacking InstructionsInstallation Camera Setup Pin Configurations 1 a 12-Pin Connector TM-67101 b 12-Pin Connector TM-6710CL 1 c 51-Pin Connector Camera Link ConnectorPower Supply and Power Cable Setup MDR 26-Pin Connector 0226-622VC3 RS-232 Cables and Connectors TM-6710 only CS-232-B912Back-Focusing the Lens Attaching the Video Output Analog Output on TM-6710 OnlyAttaching the Camera Lens Operation OperationDual-Tap Video Output Rear PanelRear Panel Layout TM-6710CL Pin Power Operation Mode Control Switches TM-6710 Mode Control Switch Up/Down SwitchModes of Operation Shutter Operation Asynchronous Reset with Shutter External Sync Input SchematicOperation External Synchronization Shutter ControlExternal Pulse Width Control Mode Vinit Input SchematicInternal Fast Reset Mode Internal Slow Reset ModePartial Scan Mode IntegrationProgressive scanning quad speed output normal mode RS-232C Communication Default ConditionOperation Progressive Scanning RS-232C Control Commands Command SManual Shutter Mode Async Shutter ModeCommand G CommandCommand W Command LCommand R Report from pages RP 0-6 command. Camera responds Command CRS-232C Control Commands Summary Table 1st Char 2nd CharOperation Video Output TimingFrame Data Valid Pixel ClockCamera Timing Charts Camera Timing ChartsAsync Reset Timing 38 P, 1.49 µsec H, 6 µsec 254 H, 8.33 msec 5 H, 147.6 µsec Troubleshooting Troubleshooting Information and Support Resources Specifications Specifications TableAppendix AppendixTM-6710 Physical Dimensions Glass Specifications Appendix Block Diagrams TM-6710 Block DiagramPage Email imaging@jaipulnix.com