JAI Spectral Sensitivity, Appendix, CV-A50 or CV-A60 emulating CV-M50 interfacing

CV-A50 / CV-A60

9. Spectral Sensitivity

	1.0
Response	0.8
	0.6
Relative	0.4
	0.2
	0.0	500	600	700	800	900	1000
	400
			Wave Length (nm)

Fig. 30. Spectral sensitivity.

10. Appendix

10.1. CV-A50 or CV-A60 emulating CV-M50 interfacing

The CV-A50 and CV-A60 have a slightly different pin configuration on the 12-pin Hirose connector, compared to the M-series. This new configuration is compliant to the EIA-J standard. This means, however, that the CV-A50 and CV-A60 are not completely backward compatible with the CV-M50, CV-M300, etc in all cases (depending on the cable configuration).

This application note gives detailed instruction on how to change the pin configuration, by changing internal solder jumpers.

Please note: Only a qualified electronics technician or engineer should make these changes.

Hirose pin #	Function	JP2	JP3	JP5	JP1	JP4	Remarks
9	PCLK output enabled	Short					Note 2
9	No connection	Open
10	WEN output		Open	Short
10	Connected to ground		Short	Open
11	Ext Trigger input				Open	Short
11	+12V DC in				Short	Open

Note : Configuration shown in Bold+Italic is factory default setting

Note 2: The RS-232C command “PC” must be set to CLK

Fig. 31. PK8279 Rear Board of CV-A50/60

- 23 -