JAI CV-A60 WEN out on pin 6 on 6 pin connector, CV-A50/60 without sync on video output

Page 25

CV-A50 / CV-A60

10.2. WEN out on pin 6 on 6 pin connector

Instead of EEN output on pin #6 on the 6 pin Hirose connector, WEN can be output by jumper settings. The 2 jumpers are found on the main board PK8275B, if the bottom plate is removed.

Signal on pin #6

JP1

JP2

Remark

EEN out

open

short

default

WEN out

short

open

 

Configuration shown in Bold+Italic is factory default setting

JP1 JP2

Fig. 32. PK8275B main board

10.3. CV-A50/60 without sync on video output.

For applications where the video output signal should be without the composite sync signal, it is possible to remove the sync signal by removing an internal resistor.

Remove the top cover and the bracket for holding boards. The resistor is found on the main board. (Mother board). The resistor, which is very small, can then carefully be removed with a small solder iron.

Front

R49 1K Remove it for video without sync.

Rear

Fig. 33. PK8275B main board top side

- 24 -

Page 24 Page 26
Image 25
Page 24 Page 26
Contents CV-A50 / CV-A60 CV-A50 / CV-A60 Table of ContentsGeneral Main FeaturesStandard Composition Camera Housing and Dimensions Pin Multi-connector Trigger and RS232C Pin Multi-connector DC-IN/VIDEO OUT, EXT.HD/VDPin Assignment Video output Input and Output CircuitsTrigger input HD and VD inputBasic functions Functions and OperationsContinuous Operation Non triggered Input-output of HD/VD SignalsCV-A50 / CV-A60 Vertical timing details for interlaced. Ccir Vertical timing details for interlaced. EIA Start/stop Mode. TR=5 External Trigger ModesImportant notes on using this mode Edge Pre-select ModePulse width control Ccir Pulse Width Control ModePage Long time exposure. Field accumulation Long Time Exposure ModeStart/stop mode. Interlaced with frame accumulation Start/Stop ModeOther Functions RS-232C control Configuring the CameraTiming and shutter related commands CV-A50/60 RS-232C command listCamera Control Tool for CV-A50/60 Selecting termination of HD/VD input signals Internal Switch and Jumper Settings1 HD/VD input-output selection CV-A50C CV-A50E CV-A60C CV-A60E SpecificationsAppendix Spectral SensitivityCV-A50 or CV-A60 emulating CV-M50 interfacing CV-A50/60 without sync on video output WEN out on pin 6 on 6 pin connectorTypical CCD Characteristics PrecautionsCamera type CV-A50/60 Users Record
Top Page Image Contents