JAI CV-A60, CV-A50 operation manual Pin Assignment, Pin Multi-connector DC-IN/VIDEO OUT, EXT.HD/VD

CV-A50 / CV-A60

5. Pin Assignment

5.1.12-pin Multi-connector (DC-IN/VIDEO OUT, EXT.HD/VD IN)

Type: HR10A-10R-12PB-01 (Hirose) male

Seen from rear.			Pin configuration is compatible with EIAJ standard
			Pin no.	Signal	Remarks
			1	GND
			2	+12 V DC input
1	9		3	GND
			4	Video output	Parallel with the BNC connector.
2	10	8
			5	GND
3 11
	12	7	6	HD input/HD output	*)	SW2.1 on for 75Ω. SW1.1 on for HD out.
4	6		7	VD input/VD output	*)	SW2.2 on for75Ω. SW1.2 on for VD out.
	5		8	GND
			9	Pixel clock output	*)	JP2 short and PC=1 for pclk out.
			10	WEN output	*) *2) GND if JP5 open and JP3 short
			11	Trigger input	*)	+12V DC if JP1 short and JP4 open
			12	GND

Fig. 2. 12-pin connector.

Plugs for cable: HR10A-10P-12S

5.2.6-pin Multi-connector (TRIGGER and RS232C)

Type: HR10A-7R-6PB (Hirose) male

Seen from rear.
		Pin no.	Signal	Remarks
		1	TXD out	RS-232C
1	6	2	RXD in	RS-232C
2	5	3	GND
3	4	4	GND
		5	Trigger input	*)	Parallel with pin 11 on 12 pin con
		6	EEN output	*)	*3) WEN out refer to chapter 10.2.

Fig. 3. 6-pin connector.

	Plugs for cable: HR10A-7P-6S
Notes:
*)	Alternative signals can be placed on these pins by switch or jumper settings or
	RS-232C commands. Refer to chapter 10.1. and 10.2. for alternative signals.
	Configurations shown in Bold + italic is factory setting.
*2)	WEN (Write Enable) pulse indicates the period of effective video signal output. It is usefull
	for setting the timing with framegrabber.
*3)	EEN (Exposure Enable) pulse indicates the duration of the shutter, and can be used for
	controlling strobe illumination.
	EEN will be low all the time in normal continous mode (TR=0), if the selected
	exposure time is longer than the video readout time.

For schematic diagram of the input and output circuit with alternative settings refer to 5.3.

- 4 -