JAI CV-A50, CV-A60 operation manual Camera Housing and Dimensions

Page 4

CV-A50 / CV-A60

4. Camera Housing and Dimensions

Fig. 1. Locations and dimensions.

1.12 pin Hirose connector for frame grabber interfacing and power (12V DC).

2.BNC connector for video output. VS 1.0 Vpp 75 Ohm.

3.6 pin Hirose connector for trigger input and RS-232C control interface.

4.Gain potentiometer for manual gain setting.

5.Mounting holes, 8 x M3. For precision mounting use only the 4 holes located at the forward part of the bottom plate.

6.1/3” or 1/2” interline-transfer type CCD sensor.

7.Lens mount for C-mount lenses. *1)

Note *1): Rear protrusion on the C-mount lens must be less than 10mm (0.4 inches approx.). When IR-cut filter is used, it must be less than 7.0 mm (0.28 inches approx.).

The IR-cut filter is placed in the C-mount thread.

The C-mount IR-cut filter must be ordered separately.

- 3 -

Image 4

Contents CV-A50 / CV-A60 Table of Contents CV-A50 / CV-A60General Main FeaturesStandard Composition Camera Housing and Dimensions Pin Multi-connector Trigger and RS232C Pin Multi-connector DC-IN/VIDEO OUT, EXT.HD/VDPin Assignment Input and Output Circuits Video outputTrigger input HD and VD inputFunctions and Operations Basic functionsInput-output of HD/VD Signals Continuous Operation Non triggeredCV-A50 / CV-A60 Vertical timing details for interlaced. Ccir Vertical timing details for interlaced. EIA External Trigger Modes Start/stop Mode. TR=5Edge Pre-select Mode Important notes on using this modePulse Width Control Mode Pulse width control CcirPage Long Time Exposure Mode Long time exposure. Field accumulationStart/Stop Mode Start/stop mode. Interlaced with frame accumulationOther Functions Configuring the Camera RS-232C controlCV-A50/60 RS-232C command list Timing and shutter related commandsCamera Control Tool for CV-A50/60 Selecting termination of HD/VD input signals Internal Switch and Jumper Settings1 HD/VD input-output selection Specifications CV-A50C CV-A50E CV-A60C CV-A60EAppendix Spectral SensitivityCV-A50 or CV-A60 emulating CV-M50 interfacing WEN out on pin 6 on 6 pin connector CV-A50/60 without sync on video outputPrecautions Typical CCD CharacteristicsUsers Record Camera type CV-A50/60