JAI CV-M91 operation manual Jumper settings inside, Short

Page 20

CV-M91

7.2.Jumper settings inside

Factory settings is shown in bold italic

HD/VD input output on pin #6 and #7 on 12 pin connector.

	Jumper			HD/VD in			HD/VD out			Remarks
	JP305			short			open			VD input/output.
	JP306			open			short			VD input/output.
	JP306			open			short
	JP308			short			open			HD input/output.
	JP309			open			short			HD input/output.
	JP309			open			short

HD/VD input on pin #6 and #7 or composite VS signal in on pin #7.

Jumper	HD/VD in	VS in		Remarks
JP312	short	open
JP313	open	short		Instead of HD and VD input on pin #6 and pin #7 a composite signal VS can
JP315	open	short		be input on pin #7. The internal sync separator will then separate HD and
JP318	short	open		VD.
JP319	open	short
Sync out/WEN out on pin #7 on 9 pin sub-D connector.
Jumper	Sync out	WEN out		Remarks
JP303	open	short
JP304	short	open

Pixel clock out on pin #9 on 12 pin on 12 pin connector.

Jumper	N. C.		Pix clk out	Remarks
JP310	Open		short	Keep JP310 open if pixel clock is not used.
Mode setting by internal jumpers
Jumper	Normal		Edge pre-s	Pulse width	Start/stop	Long time	Remarks
JP311		short		open	short	short
JP301		open		open	short	open
JP302		open		open	open	short

- 19 -

Image 20

Contents CV-M91 Table of Contents CV-M91Standard Composition Main FeaturesGeneral Locations and Functions LocationsPin Multi-connector DC-IN/Trigger Pin Multi-connector Trigger and RS232CPin no Signal Remarks Pin AssignmentPin Sub D-connector Video Input and Output CircuitsPin no Video outputsPrism unit HD, VD, WEN, EEN and Pclk outputInput/output of HD/VD Input/Output of SignalsFunctions and Operations Internal sync out/WEN out Internal pixel clock outVBS out on pin#4 12 pin Out/VBS out on pin#6 9 pin sub-DTrigger Modes Long time integrationContinuous Operation Non triggered PAL horizontal timingVertical timing PAL interlaced Vertical timing Ntsc interlaced Edge Pre-select Mode Vertical timing for edge pre-select PALPulse Width Control Mode Vertical timing for pulse width control PALStart Stop Mode Start stop interlaced field integrationLong time integration Long time interlaced field integrationOther Functions Configuring the Camera Switch settingsSwitch settings inside 1. SW1 on rear panelJumper settings inside ShortSwitch and jumper positions Board positionsCV-M91command list RS-232C controlCamera Control Tool for CV-M91 Window from camera control toolSpectral sensitivity External Appearance and DimensionsSpecifications Specification table CV-M91PCV-M91 Opto-mechanical specifications Opto mechanical specificationsAppendix PrecautionsTypical CCD Characteristics Camera type CV-M91 Revision Revision a Serial No …………… Users Mode Settings Users ModificationsUsers Record