JAI CV-M91 External Appearance and Dimensions, Specifications, Spectral sensitivity

Page 24

CV-M91

8. External Appearance and Dimensions

Important notes.

•C-mount thread on lens should be less than 4.0 mm.

•Use only lenses designed for 1/3” 3 CCD cameras.

Fig. 41. Outline.

9. Specifications

9.1. Spectral sensitivity

The resulting relative response for the prism and the CCD sensor characteristics combined.

Relative response

1.0

0.8

B

G

R

0.6

0.4

0.2

0.0	500	600	700	800
400

Wave length (nm)

Fig. 42. Spectral sensitivity for CV-M91

- 23 -

Image 24

Contents CV-M91 Table of Contents CV-M91Main Features GeneralStandard Composition Locations and Functions LocationsPin Multi-connector DC-IN/Trigger Pin Multi-connector Trigger and RS232CPin no Signal Remarks Pin AssignmentPin Sub D-connector Video Input and Output CircuitsPin no Video outputsPrism unit HD, VD, WEN, EEN and Pclk outputInput/Output of Signals Functions and OperationsInput/output of HD/VD Internal sync out/WEN out Internal pixel clock outVBS out on pin#4 12 pin Out/VBS out on pin#6 9 pin sub-DTrigger Modes Long time integrationContinuous Operation Non triggered PAL horizontal timingVertical timing PAL interlaced Vertical timing Ntsc interlaced Edge Pre-select Mode Vertical timing for edge pre-select PALPulse Width Control Mode Vertical timing for pulse width control PALStart Stop Mode Start stop interlaced field integrationLong time integration Long time interlaced field integrationOther Functions Configuring the Camera Switch settingsSwitch settings inside 1. SW1 on rear panelJumper settings inside ShortSwitch and jumper positions Board positionsCV-M91command list RS-232C controlCamera Control Tool for CV-M91 Window from camera control toolExternal Appearance and Dimensions SpecificationsSpectral sensitivity Specification table CV-M91PCV-M91 Opto-mechanical specifications Opto mechanical specificationsPrecautions Typical CCD CharacteristicsAppendix Users Mode Settings Users Modifications Users RecordCamera type CV-M91 Revision Revision a Serial No ……………