JAI operation manual RS-232C control, CV-M91command list

Page 22

CV-M91

7.3. RS-232C control

The CV-M91 camera functions can be set up via the RS-232C port on the 6 pin HR connector. The JAI camera control tool for CV-M91 can be used for it.

To use this mode:
Set function:	Control. SW1-8 on rear to ON. RS-232C. (Switch setting before power on).
	Other functions

Important notes on using this mode.

	•
Communication setting.

	Baud Rate	9600 bps
	Data Length	8 bit
	Start Bit	1 bit	RS 232C cable
	Stop Bit	1 bit	RS 232C cable
	Parity	None
	Xon/Xoff Control	None

					1 CD
					1 CD
					4 DTR
					4 DTR
					6 DSR	9 pin
					6 DSR	9 pin
TXD					2 RXD	D-con
TXD					2 RXD	D-con
CAMERA RXD					3 TXD	PC COM
CAMERA RXD					3 TXD
GND					5 GND
GND					5 GND	PORT
					7 RTS
					8 CTS
					8 CTS
					9 CI

7.4. CV-M91command list

The following functions can be controlled via the camera control tool.

Shutter speed

1/60 to 1/10,000 sec.

Mode

Normal, random trigger

Scanning

2.1interlaced, non-interlaced

Accumulation Frame, field

Gamma

Gamma 1.0, gamma 0,45

AGC

AGC off, AGC on, manual gain, AGC reference level

CCD iris

CCD iris on. CCD iris off, CCD iris reference level

White balance

One push, manual, red gain, blue gain, green gain

White clip level

Red white clip, blue white clip, green white clip

Offset level

Red offset, blue offset, green offset

Load user settings

Load factory, user 1, user 2

Save user settings

Save user 1, save user 2. (Last saved user settings become default at next power-up.)

-21 -

Image 22

Contents CV-M91 Table of Contents CV-M91General Main FeaturesStandard Composition Locations and Functions LocationsPin no Signal Remarks Pin Multi-connector DC-IN/TriggerPin Multi-connector Trigger and RS232C Pin AssignmentPin no Pin Sub D-connector VideoInput and Output Circuits Video outputsPrism unit HD, VD, WEN, EEN and Pclk outputFunctions and Operations Input/Output of SignalsInput/output of HD/VD VBS out on pin#4 12 pin Internal sync out/WEN outInternal pixel clock out Out/VBS out on pin#6 9 pin sub-DTrigger Modes Long time integrationContinuous Operation Non triggered PAL horizontal timingVertical timing PAL interlaced Vertical timing Ntsc interlaced Edge Pre-select Mode Vertical timing for edge pre-select PALPulse Width Control Mode Vertical timing for pulse width control PALStart Stop Mode Start stop interlaced field integrationLong time integration Long time interlaced field integrationOther Functions Switch settings inside Configuring the CameraSwitch settings 1. SW1 on rear panelJumper settings inside ShortSwitch and jumper positions Board positionsCV-M91command list RS-232C controlCamera Control Tool for CV-M91 Window from camera control toolSpecifications External Appearance and DimensionsSpectral sensitivity Specification table CV-M91PCV-M91 Opto-mechanical specifications Opto mechanical specificationsTypical CCD Characteristics PrecautionsAppendix Users Record Users Mode Settings Users ModificationsCamera type CV-M91 Revision Revision a Serial No ……………