Hitachi HV-D30 operation manual File set, Other Func

9)SC.FINE : Fine adjustment of subcarrier phase The allowable setting range is -128 to 127.

There is no direct relationship between a numeric value and a degree of phase. If the relevant range is exceeded, the SC COARSE setting is updated automatically to permit continuous adjustment.

10)H.PHASE : Adjustment of horizontal synchronization phase

The allowable setting range is -128 to 127.



15. File set

Use for transferring scene file data to another file or setting all data to preset values.

1)FILE SELECT : Selects scene file 1 - 4 or preset for copy data.

2)STORE FILE : Selects file for storing scene file data.

3)STORE : Press L and R for more than 1 second to transfer selected scene file data to store file.

4)STORE PRESET : Press L and R for more than 1 second to initialize selected scene file data to preset values.

5)All INITIALIZE : Press L and R for more than 1 second to initialize all scene file data to preset values.



16. OTHER FUNC



1) FLARE : Flare compensation on/off

Corrects for extraneous reflections in the optical and CCD systems which end to weaken bright image components. Normally set to on.

2)FLARE LEVEL: Setting range is -128 (smaller) to 127 (larger compensation). Press L and R for about 2 seconds to set to 0.

3)KNEE POINT: Use L and R to set in the range -128 (smaller) to 127 (larger). Press both L and R for about 2 seconds to set to 0. Normally set to where gradation appears above 100% video level.

4)WHITE CLIP : Sets white clip level

Use L and R to set in the range of -128 (lower) to 127 (higher) clip level. Press both L and R for about 2 seconds to set to 0. Normally set for clip at about 110% video level. Adjust when there is excess video level from the equipment interface.



30