RCA Pro884HB manual Removing and Replacing the Light Bulb

Optional Color Enhancement Light

Cautions: After using the light, be sure to allow it sufficient time to cool down completely.

Use only bulb (VLB04) when replacing the bulb to reduce the risk of fire or other hazards.

Do not use the light when powering your camcorder with the optional car cord adapter because the car cord will become very hot.

Dangers: During operation and after using the light, the front surface and bulb of the light will be very hot. To avoid burns, do not touch them.

To prevent overheating, do not block or cover the ventilation holes on the color enhancement light.

Never use the light in the vicinity of explosives or highly flammable materials.

Removing and Replacing the Light Bulb

Bulb

Bulb Base

Notch

5 Mark

1.Turn the case front counterclockwise to remove it.

2.Remove the bulb by pulling it out through the open case.

3.Hold the new bulb with a soft cloth and align the notch in the rim of the bulb’s base with the 5 mark outside the socket.

Note: When replacing the light’s bulb, use only Stock #VLB04 to reduce the risk of fire and other hazards. See the installation instructions packed with the replacement bulb when replacing the bulb.

Raised Marks (—)

4.Reattach the case front by placing the bulb in the hole of the reflective plate, lining up the smaller raised mark (–) on the front of the cover with the raised mark (—) on the light’s case. Then turn the front clockwise until the larger raised mark (—) on the front cover aligns with the mark on the case.

51