IBM 2194, 6345, 2193 manual Quick Power-On Self Test, Boot Up Floppy Seek, Boot Up NumLock Status

Afterwards, if necessary, you will be able to run an anti-virus program to locate and remove the problem before any damage is done.

	Activates automatically when the system boots up causing a warning mes-
Enabled	sage to appear when anything attempts to access the boot sector or hard
	disk partition table.
Disabled	No warning message will appear when anything attempts to access the
	boot sector or hard disk partition table.

Note:

Many disk diagnostic programs that attempt to access the boot sector table can cause the above warning message. If you are running such a program, you can avoid the virus warning by disabling the virus protection before you run the program. After running the program, remember to re-enable virus protection.

Quick Power-On Self Test

This setting causes the computer to run a shortened power-on self test (POST). The shortened POST takes less time to complete, but does not test the computer as thoroughly as the normal POST.

Enabled	Enable quick POST
Disabled	Normal POST

Boot Up Floppy Seek

This setting determines whether or not the computer will check for the presence of a diskette drive at startup.

Boot Up NumLock Status

This setting determines the default state of the numeric keypad. By default, the system boots up with NumLock on.

On

Off

The numeric keypad provides numeric functions.

The numeric keypad provides arrow-key, Home, PgUp, PgDn, End, Insert, and Delete functions.

BIOS Setup configuration 6-13