IBM 2194, 6345, 2193 manual Removing adapter cards

If you disconnected any cables to gain access to the adapter card connector on the system board, reconnect the cables.

Removing adapter cards

Note:

If you are permanently removing the factory-installed modem or replacing the modem with a different type, use the Windows Add/Remove Software feature in the Control Panel to remove the modem software. You must remove the modem software before removing the modem or installing a different modem.

Follow these steps to remove an adapter card:

1.Position the system unit so that the card is accessible to you.

2.If the adapter card has cables, disconnect them. Be sure to take note of where the cables are connected. You will have to reconnect these cables when you reinstall the card.

3.Remove the adapter card screw.

4.Firmly hold the adapter card and carefully pull it from the card connector.

5.If you are not reinstalling the adapter card, reinstall all other hardware and screws that you removed prior to the removal of the adapter card.

Adding and removing adapter cards and drives 8-5