Cenix Digicom 67980 manual Installation and Connection, Imager Head and Cable Installation

Page 10

Installation and Connection

Accessories Installation

3. Installation and Connection

3.1 The Imager Head and Cable Installation

To use the tool, the imager head and cable must be connected to the display unit. To connect the cable to the display unit, make sure the key and slot (Fig. 4) are properly aligned. Once they are aligned, slide the connecting sleeve up to the threads on the cable, and finger-tighten to hold the connection firmly in place.

Fig. 4

8

Image 10

Contents Page Table of Contents Work Area Safety Safety InstructionsElectrical Safety Personal Safety Specifications Description, Specifications and Tool ComponentsDescription Accessories Included Tool Components Buttons and Ports Installation and Connection Installation and Connection Imager Head and Cable InstallationAccessories Installation SD Card Installation USB Cable ConnectionVideo-Out Cable Connection Earphone ConnectionBattery Charging Safety Battery Charging PrecautionsBattery and Charger Specifications Battery Charging Procedures Charger InspectionBattery Charging Procedures Operation Instructions Basic OperationOperation Precautions Tool Inspection Tool and Work Area Set-Up Operation Instructions On Screen Navigation Splash ScreenZooming Capturing a Photo Playing Back and Deleting Captured Photos and Videos Operation Instructions Entering the Secondary Settings Screen Operation Instructions Icons  Advanced Settings is the default mode from the Setup menu Operation Instructions  If you select Yes, a message Warning this will erase ALL Operation Instructions  Select Restore Defaults from Advanced Settings and press OK button  English is the default language Troubleshooting Symptoms Possible Solutions ReasonsParts List and Diagram Item # DescriptionParts List and Diagram