Operation Instructions | Tool and Work Area |
Turn on the power and make sure the tool starts up as described in the Basic Operation section.
If the tool does not work well after turning it on, have the tool checked by a qualified technician. Any tool that cannot be controlled with the power button is dangerous and must be repaired.
NOTE: Please check following methods to avoid injury.
FOR WALLS: For inspecting inside walls, shut off the circuit breaker to the whole house before using the tool.
FOR PIPES: If you suspect a metal pipe could contain an electrical charge, have a qualified electrician check the pipe before using.
FOR AUTOMOBILES: Be sure the automobile is not running during inspection. Metal and liquid under the hood may be hot. Do not get oil or gas on the imager head.
5.4Tool and Work Area Set-Up
CAUTION: Set up the tool and work area according to these procedures to reduce the risk of injury from electric shock, entanglement, and other causes and prevent tool damage.
1)Check work area for:
Sufficient lighting.
Do not work in an area until flammable sources have been identified and corrected. The tool is not explosion proof and can cause sparks.
Do not use the tool while standing in water.
2)Check the area and determine if the Inspection Camera is the correct tool for the job.
Check the access points to the area.
Check if there is any electric power supplied to the area to be inspected.
18