Operation Instructions | Tool and Work Area |
Check if any liquids will be contacted during inspection. The imager head and cable are waterproof to a depth of 3m (10'). Greater depths may cause leakage into the imager head and cable and cause electric shock or damage the tool. The display unit is not waterproof and should not be exposed to wet conditions.
Check if any chemicals are present, especially in the case of drains. Chemicals may damage the tool.
Check the temperature of the area. The working temperature of the tool is between 32°F (0°C) and 113°F (45°C).
Check if any moving parts are present in the area.
3)Make sure the tool has been properly inspected.
4)Install the correct accessories for use in the appropriate application.
CAUTION: Make sure the tool has been powered off before performing maintenance.
Tool maintenance must be performed only by qualified repair personnel. Maintenance performed by unqualified repair personnel could cause injury.
When maintaining, use only identical replacement parts. Use of unauthorized parts or failure to follow maintenance instructions may create a risk of electric shock or injury.
Do not attempt to take any pieces of the tool apart unless directed by the manual.
Follow instructions to change accessories.
Do not use acetone to clean the tool. Instead, use only alcohol to swab the connections. Avoid rubbing too hard on the LCD screen. After using, wipe the display unit clean gently with a dry cloth.
Upon the completion of any maintenance of the tool, ask qualified repair personnel to perform safety checks to examine if the tool is in proper operating condition.
Stop using the tool if it starts smoking or emitting noxious fumes.
Always handle the tool with care. It is not
Do not disassemble the tool beyond what is shown in the manual. Doing so will void your warranty.
19