Operation Instructions | Tool Inspection |
breakage and any other condition which may affect its operation.
Use only accessories that are recommended by the manufacturer for the tool.
Dry your hands before operating the tool or charging the battery.
Always use appropriate personal protective equipment while handling and using the tool. Appropriate personal protective equipment always includes safety glasses and gloves, and may include latex or rubber gloves, face shields, goggles, protective clothing, respirators and steel toed footwear.
Protect against excessive heat. The tool should be kept away from heat sources such as radiators, stoves or others products that produce heat. Do not use the tool near moving machinery or areas where the temperature will exceed 113°F (45°C).
Store the tool, charger and all cables in a locked area out of the reach of children and people unfamiliar with the tool.
5.3Tool Inspection
WARNING: Before using, inspect your tool and correct any problems to reduce the risk of serious injury from electric shock and other causes and to prevent damage to the tool.
Make sure the power is OFF.
Clean any oil, grease or dirt from the tool, especially on the buttons and ports. This helps to prevent the tool from slipping from your hands.
Inspect the imager head lens for condensation. To avoid damaging the tool, do not use the tool if condensation forms inside the imager head. Let the water evaporate before using again.
Inspect the full length of the cable for cracks or damage. A damaged cable could allow water to enter the tool and increase the risk of electric shock.
Make sure the connections between the display unit and imager head and cable are tight. All connections must be properly assembled for the cable to be waterproof.
Check if the warning label is present, firmly attached and readable. Do not operate the tool without the warning label.
17