Fairchild CAM/CMOS-2K.LS Power Supply, Camera Pin # Frame Grabber Pin # Channel Link Signal

Table 2.2.1

Camera Pin #	Frame Grabber Pin #	Channel Link Signal
1	1	Inner shield
14	14	Inner shield
2	25	X0
15	12	X0+
3	24.0	X1-
16	11	X1+
4	23	X2-
17	10	X2+
5	22	Xclk
18	9	Xclk+
6	21	X3
19	8	X3+
7	20	SerTC+
20	7	SerTC-
8	19	SerTFG-
21	6	SerTFG+
9	18	CC1-
22	5	CC1+
10	17	CC2-
23	4	CC2+
11	16	CC3-
24	3	CC3+
12	15	CC4-
25	2	CC4+
13	13	Inner shield
26	26	Inner shield

Notes:

•Exterior overshield is connected to the shells of the connectors on both ends.

•3M part 14X26-SZLB-XXX-0LC is a complete cable assembly, including connectors.

•Unused pairs should be terminated in 100 ohms at both ends of the cable.

2.3 Power Supply

•The camera uses a single voltage input, normally set to 5.0V.

•Ripple and noise is required to be < 20 mV RMS.

•Power is supplied through a Hirose connector.

•When installing the mating connector, be sure to line up the slots. This action will assure that you will not bend any of the pins.

Fairchild Imaging • CAM/CMOS-2K.LS Line Scan Camera User’s Manual • Rev C• 12 of 42