Fairchild CAM/CMOS-2K.LS user manual Lensing, Lens Mount Extender Tube

Page 27

4.2 Lensing

The CAM/CMOS – 2K.LS as shipped from the factory accepts universal manual "F" mount lenses that are available from a number of suppliers. The standard 0.050" Nikon mounting ring is shown in Figure 4.3 below.

Figure 4.3 below shows that the lens extender tube can be detached by unscrewing it so that an optional "C" mount can be installed. If you wish to do this, please contact your Fairchild Imaging Sales representative.

With the lens mount (lens extender tube and its lockring) removed, the front surface of the camera is seen as a square with a large threaded hole in the center. The "z" distance from the surface of the square to the top of the sensor is 13.72mm.

4.3 Lens Mount Extender Tube

Figure 4.3.1

Fairchild Imaging • CAM/CMOS-2K.LS Line Scan Camera User’s Manual • Rev C• 27 of 42

Image 27

Contents OWL Camera Series CAM/CMOS-2K.LS EMC EMC ConformanceTerminology CAM/CMOS-2K.LS Line Scan Camera Rev B Fairchild Imaging, IncTable of Contents Camera Link Introduction TroubleshootingHandling Instructions Product SupportUsability Camera HighlightsDescription ProgrammabilityFull Spectrum of Applications Camera Specification RDI and Mrdi Performance SpecificationLink Thermal ConsiderationsRDI and Mrdi Responsivity Curve Image Sensor Page Installation Overview Connectors, Pinouts, and CablesCamera Hardware Interface Camera Pin # Frame Grabber Pin # Channel Link Signal Power SupplyLED Indicator Status Lamp Hirose ReceptacleBack View of CAM/CMOS 2K.LS Commands Camera ControlQuick Start with the Camera LinkTM Interface You must cover lens when performing this operation SSM LED Command Definition Summary Camera Command SummaryGSN Four Modes for Synchronizing with the CAM/CMOS 2K.LSSummary of CAM/CMOS-2K.LS Modes Line Start End 1 -- Mode 1 Freerunning 2 -- Mode 2 ExSync Synchronization ExSync Camera Input LineValid Camera Output ElectShutter CAM/CMOS-2K.LS Synchronization Timing ValuesMechanical and Optical Guidance Camera Dimensions and Mounting FacilitiesLens Mount Extender Tube LensingPage Page Light Sources LensesPositioning Accuracy of the Sensor Chip in the Camera IlluminationLens Modeling Preventing ESD Damage Cleaning the Sensor WindowHandling Instructions Electrostatic DischargeOther Areas You Should Check TroubleshootingCheck the Obvious Things Out First Use the Camera Control Interface to Perform ChecksHorizontal Lines or Patterns in Output Data Clocking/Output SignalsNo Output Or Non Specification Output Everything Seems To Be Working, But No ImageProduct Support Camera LinkTM Introduction Channel Link is a Widely-Used Signaling MethodVideo Data Signals Camera Control SignalsCommunication Power Port AssignmentsFor More Information on CameraLinkTM Figure A.1 Channel Link Operation Camera Link Connections -- the MDR 26-Pin ConnectorPage Page Figure A.4 Camera Link Cable