Fairchild CAM/CMOS-2K.LS user manual Camera Command Summary, Command Definition Summary

Page 18

SBS

	Value	Function
Set bit shift	0	12 bit
	1	10 bit
	2	8 bit

CAO

Adjust analog video offset mismatch. Calibrate analog offset 200 DN.

SAG

Set analog gain 0 – 10 db

CAG

Adjust analog video gain mismatch. Calibrate analog gain.

GSN

Get camera serial number, returns 128 character string: serial number, model, etc.

SGH

Set gain high. Set pixel gain in sensor.

SGL

Set gain low. Set pixel gain in sensor.

3.3 Camera Command Summary

	Table 3.3.1

Command	Definition	Summary
RSH	Reboot System Hard	Hard reboot of camera
RSS	Reset Command	Logic reset of camera
INQ	Inquiry	Shows what camera is used
VER	Version	Shows current software
SLR	Set Line Rate	This function allows line rate change
CPO	Calibrate Pixel Offset	This function performs correction of pixel
		offset
CPG	Calibrate Pixel gain	This function performs correction of pixel
		gain
VOM	Voltage monitoring	This function shows internal voltages
TSB	Temperature Sensor Board	This function shows temp. of sensor board
SIT	Set Integration Time	This function allows user to set integration
		time
SSM	Set Sync Mode	This function allows user to select sync
		mode
SCM	Select Correction Mode	This function allows user to select
		correction mode
STP	Select Test Pattern	This function allows user to select test
		pattern

Fairchild Imaging • CAM/CMOS-2K.LS Line Scan Camera User’s Manual • Rev C• 18 of 42

Image 18

Contents OWL Camera Series CAM/CMOS-2K.LS EMC Conformance EMCCAM/CMOS-2K.LS Line Scan Camera Rev B Fairchild Imaging, Inc TerminologyTable of Contents Product Support TroubleshootingHandling Instructions Camera Link IntroductionProgrammability Camera HighlightsDescription UsabilityCamera Specification RDI and Mrdi Performance Specification Full Spectrum of ApplicationsThermal Considerations LinkRDI and Mrdi Responsivity Curve Image Sensor Page Installation Overview Connectors, Pinouts, and CablesCamera Hardware Interface Power Supply Camera Pin # Frame Grabber Pin # Channel Link SignalLED Indicator Status Lamp Hirose ReceptacleBack View of CAM/CMOS 2K.LS Commands Camera ControlQuick Start with the Camera LinkTM Interface You must cover lens when performing this operation SSM LED Camera Command Summary Command Definition SummaryFour Modes for Synchronizing with the CAM/CMOS 2K.LS GSNSummary of CAM/CMOS-2K.LS Modes Line Start End 1 -- Mode 1 Freerunning 2 -- Mode 2 ExSync Synchronization ExSync Camera Input LineValid Camera Output ElectShutter Synchronization Timing Values CAM/CMOS-2K.LSCamera Dimensions and Mounting Facilities Mechanical and Optical GuidanceLensing Lens Mount Extender TubePage Page Illumination LensesPositioning Accuracy of the Sensor Chip in the Camera Light SourcesLens Modeling Electrostatic Discharge Cleaning the Sensor WindowHandling Instructions Preventing ESD DamageUse the Camera Control Interface to Perform Checks TroubleshootingCheck the Obvious Things Out First Other Areas You Should CheckEverything Seems To Be Working, But No Image Data Clocking/Output SignalsNo Output Or Non Specification Output Horizontal Lines or Patterns in OutputProduct Support Channel Link is a Widely-Used Signaling Method Camera LinkTM IntroductionVideo Data Signals Camera Control SignalsCommunication Power Port AssignmentsFor More Information on CameraLinkTM Camera Link Connections -- the MDR 26-Pin Connector Figure A.1 Channel Link OperationPage Page Figure A.4 Camera Link Cable