Samsung SHC-750 user manual White Bal, Motion Det

Page 14

Instruction: Camera Operation

White Bal

Use the White Balance feature for screen color control.

1.After the Setup menu is displayed, press the Up/Down buttons to move the arrow to “White Bal.”

2.Press the Left/Right buttons to select a mode.

 

SETUP

 

CAMERA

ID

OFF

BACKLIGHT

OFF

WHITE BAL.

ATW

MOTION

DET.

OFF

Choose from the three modes shown below

ATW : One of the two modes below can be selected

Normal - Use when the color temperature is between 1800~10500K

Special - Use when the color temperature is between 1600~10500K

AWC : To find the optimum setting for the current illumination, point the camera at a piece of white paper and then press the Set button. Repeat the process when the illumination changes.

Manual: Manual control allows finer adjustments. Set the camera to ATW or AWC mode first, and then change to Manual mode. Press the Set button. Decide on the proper color temperature, and then adjust the values of Red and Blue while observing the color changes of the subject on the screen.

Caution

The White Balance may not function properly under the following conditions.

If the subject’s environment has very high color temperatures (e.g. clear sky or sunset).

If the subject is in a dark environment

If the camera is directly facing a fluorescent light, or if it is subject to extreme fluctuations of light, the White Balance function may become unstable.

COLOR CCD CAMERA 26 User’s Manual

Motion Det

This product generates a signal whenever motion is detected. Connecting an alarm device to the product, therefore, may increase security efficiency. Motion detection signals are output through the MD output port.

1.After the Setup menu is displayed, press the Up/Down buttons to move the arrow to “Motion Det.”

2.Press the Left/Right buttons to select a mode (On/Off).

SETUP

 

CAMERA ID

OFF

BACKLIGHT

OFF

WHITE BAL.

ATW

MOTION DET.

OFF

LENS

DC

3.Press the Exit button to save the settings and exit. Caution

Perform a lengthy test after setting MD, to confirm everything is operating properly.

Use of the MD feature is not recommended if the camera is subject to direct fluorescent light or extreme fluctuations of light; malfunction may occur.

Sudden changes in subject illumination due to flashlights or fluorescent lighting being turned on/off may cause malfunction.

Other automatic algorithm execution speeds may slow down when the motion detection feature is active.

• This feature is NOT suitable for fires, burglary, or other similar security purposes. The manufacturer will not be responsible for any accidents or loss that may occur under these circumstances.

• The MD output port located on the back of the product can be connected to external alarm devices.

COLOR CCD CAMERA 27 User’s Manual

Image 14
Contents Ultimate Page Major Functions and Features Contents Precautions Heat or coldProduct Components Names and Functions of Each PartGroove for Tripod Mount Function ButtonsInstructions Setup Names and Functions of Each PartWhen using a C/CS-mount lens Using DC Power Instruction ConnectionBacklight Menu FunctionsCamera ID Motion DetSelect Exit and then press the Set button to exit Camera IDUse the Left/Right buttons to change the current value Press the Set buttonBackLight White Bal Motion DetShutter This feature controls the brightness of the screenLens Selection Select either auto or manual shutter controlAuto Gain Control Sens-UpExit You can turn the Burst signal ON/OFFSpecial Remote Control / MD Output / D&N Input RS-485C Communication setting Mode Serial Data BitProduct Specification Problems & SolutionsProtocol Command Description Memo Memo