Samsung SHC-750 user manual

Page 2

The lightning flash with an arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

INFORMATION -This equipment has been tested and found to comply with limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

WARNING - Changes or modifications not expressly approved by the manufacturer

could void the user’s authority to operate the equipment.

CAUTION : To prevent electric shock and risk of fire hazards:

Do NOT use power sources other than that specified.

Do NOT expose this appliance to rain or moisture.

This installation should be made by a qualified service person and

should conform to all local codes.

Image 2
Contents Ultimate Page Major Functions and Features Contents Precautions Heat or coldProduct Components Names and Functions of Each PartGroove for Tripod Mount Function ButtonsInstructions Setup Names and Functions of Each PartWhen using a C/CS-mount lens Using DC Power Instruction ConnectionBacklight Menu FunctionsCamera ID Motion DetSelect Exit and then press the Set button to exit Camera IDUse the Left/Right buttons to change the current value Press the Set buttonBackLight White Bal Motion DetShutter This feature controls the brightness of the screenLens Selection Select either auto or manual shutter controlAuto Gain Control Sens-UpExit You can turn the Burst signal ON/OFFSpecial Remote Control / MD Output / D&N Input RS-485C Communication setting Mode Serial Data BitProduct Specification Problems & SolutionsProtocol Command Description Memo Memo