Names and Functions of Each Part
Auto Iris Lens Selection Switch
Set to DC or Video according to the lens in use
Video Output Port
For video signal output; connects to a monitor video input port
Instructions: Setup
Lens
Lenses are sold separately. Auto iris,
Caution
•For maximum utilization of the product’s features, we recommend the use of a
•Any dirt or smudges including fingerprints may reduce the picture quality in low light conditions; please keep it clean.
When using an auto iris lens
1. Strip the outer layer of the lens cable for about 8mm (0.3in) from the end.
2. Strip the inner layer of the cable for about 2mm (0.08in) from the end.
COLOR CCD CAMERA 14 User’s Manual
3. Remove the cover from the lens connector jack and solder the cable to the jack pins.
• Video type : |
| • DC type : |
|
No. 1 Pin | Red (Power source) | No. 1 Pin | Damping - |
No. 2 Pin | N.C | No. 2 Pin | Damping + |
No. 3 Pin | White (Video signal) | No. 3 Pin | Drive + |
No. 4 Pin | Black (GND) | No. 4 Pin | Drive - |
| Lens Cable |
| pin3 |
pin1 | Connector |
| |
| pin4 |
| pin2 |
4.Replace the cover to the lens connector jack. Remove the front glass protector from the product and fit an auto iris lens by screwing the lens in clockwise.
5.Insert the connector jack, now soldered to the lens cable, into the lens connector port located on the side of the product.
6. Set the lens selection switch located on the side either to DC or to Video according to the type of auto iris lens now in use.
COLOR CCD CAMERA 15 User’s Manual