Instruction: Camera Operation
Caution
•When using a video auto iris lens and if the lens level is set to low, automatic switching between Color mode and B/W mode may not work properly.
•When the Gain menu is Off, the Color/B&W auto switch feature is not available.
•When the Gain menu is Off, only Color/B&W/Ext may be selected from the Day/Night menu.
•When switching between Color and B&W, the OSD key will be disabled for about 3 seconds for safer operation of the product.
•When infrared light is used, camera focus may not be as good as when using other light sources.
Image : Image may be reversed horizontally or vertically
-HRev: Reverse the image horizontally
-VRev: Reverse the image vertically
-HVRev: Reverse the image both horizontally and vertically
Remote Control / MD Output / D&N Input
To Remotely Control Function Buttons: Connect a remote jack to the Remote port located on the back of the product and wire it as shown below. External device (e.g. computer) buttons may act identically to the camera buttons, and perform the same functions.
TX (Data transmission) |
GND (Connection port)
RX (Data reception)
1. |
| |
• Mode : Serial | • Data Bit : 8 | • Bit/sec : 9600bps |
• Stop Bit : 1 | • Parity : None |
|
2.Setup Menu control
3.Motion Detection signal output level (10mA or lower)
Sharpness : Values are 0~31. The lower the value, the more vivid and sharp the image. If the Sharpness level is too low, the image may look unnatural or noise may occur.
Smear Cancel : DGain values are 0~100. As this value decreases, the smear gets stronger and sharper, and vice versa. Too high a level may distort the image.
0V
When no motion is detected
+4.0V ~ +5.0V
When motion is detected
5±0.5sec
Reset : Resets all settings back to the manufacturer’s defaults.
Return : Saves the special menu and moves to the Setup menu. 
Exit : Saves the menu settings and exits the program.
COLOR CCD CAMERA 34 User’s Manual
4. D&N Input
In order to control a D&N filter using external signals (Ext mode), the system must satisfy the following criteria.
• Day mode : D&N port must NOT be located near the external signal port (GND port).
• Night mode : D&N port must be connected to the GND port.
Caution
•Please turn the power OFF before plugging/unplugging the remote jack.
•Do not connect any unnecessary pins (i.e. pins not in use)
COLOR CCD CAMERA 35 User’s Manual