Samsung SHC-750 user manual Special, You can turn the Burst signal ON/OFF, Exit

Page 17

Instruction: Camera Operation

SSNR

Low light noise is reduced in different ways depending on the mode; the noise reduction level changes from none to maximum as the mode changes from Off to Low, Middle, and High.

1. After the Setup menu is displayed, press the Up/Down buttons to move the arrow to “SSNR.”

SETUP

 

CAMERA ID

OFF

BACKLIGHT

OFF

WHITE BAL.

ATW

MOTION DET.

OFF

LENS

DC

SHUTTER

MANUAL

AGC

HIGH

SENS-UP

OFF

SSNR

MIDDLE

SPECIAL

 

EXIT

 

2. Press the Left/Right buttons to select a mode.

Off

: No noise reduction

Low

: Low noise reduction with almost no ghost image

Middle : Probably the most practical mode, with enough noise reduction and not too much ghost image

High : Maximum noise reduction, but the ghost image increases as well

Caution

• When AGC is Off, the SSNR & Sens-Up features are not available.

COLOR CCD CAMERA 32 User’s Manual

Special

1.After the Setup menu is displayed, press the Up/Down buttons to move the arrow to “Special.”

2.Press the Left/Right buttons to select a mode.

Privacy : Masks selected areas from the screen

- Off

: Off

- On

: Privacy mode is currently On

Press the Set button

Select an area to mask from the 4 areas in Area Sel

Change the Area State of the selected area to On

From Area Tone, press the Left/Right buttons to control the brightness

Set the area size from the Top/Down/Left/Right menu, and then press the Set button.

Color

: Select Color or B/W mode

- On

: Always provide color images

- Off

: Always provide images in B/W If you press ‘SET’, a menu will appear in which

 

you can turn the BURST signal ON/OFF.

 

By adjusting ON/OFF, you can maintain or eliminate the BURST signal.

- Auto : Use color and switch to B/W only when illumination level gets very low

- Exit

: The filter can be changed by signals from external devices.

COLOR CCD CAMERA 33 User’s Manual

Image 17
Contents Ultimate Page Major Functions and Features Contents Heat or cold PrecautionsNames and Functions of Each Part Product ComponentsFunction Buttons Groove for Tripod MountNames and Functions of Each Part Instructions SetupWhen using a C/CS-mount lens Instruction Connection Using DC PowerCamera ID Menu FunctionsBacklight Motion DetUse the Left/Right buttons to change the current value Camera IDSelect Exit and then press the Set button to exit Press the Set buttonBackLight Motion Det White BalLens Selection This feature controls the brightness of the screenShutter Select either auto or manual shutter controlSens-Up Auto Gain ControlExit You can turn the Burst signal ON/OFFSpecial RS-485C Communication setting Mode Serial Data Bit Remote Control / MD Output / D&N InputProblems & Solutions Product SpecificationProtocol Command Description Memo Memo