Sony 560TVL user manual Installation Procedures, Rear View, When Using Auto Iris Lens

Page 8
*High Voltage Type
(SHC-745PH)

Overview

Rear View

Function Setup Button

SET Button : Displays the menu on the screen. Press this button to confirm status or after changing a selected item.

Up and Down Button : Used to move the cursor up or down in the menu screen to select a desired menu item.

Left and Right Button : Used to move the cursor left or right in the menu screen or to change the value of the selected item.

D & N Input Port

You can switch to Day & Night Mode by connecting an external signal to this port.

MD Output Port

Motion detection signals are output through this port.

RS-485 Control Port

You can control SETUP MENU through this port by using external controllers like a Remote controller that RS-485 Communication is supported. For details, see page 21.

Video OUT Port

Video signals are output through this port. Connect this port to the Video IN port of a monitor.

Power LED

When power is properly connected, this LED comes on.

Power IN Port

Connect the power as specified for each model here.

Installation Procedures

Lens

The lens is not supplied with this camera. Purchase a lens suitable for your environment. This camera accepts the auto iris lens and both C-and CS-mount lens.

Notes

¥It is recommended to use the DC type Auto Iris Lens to effectively enjoy the major functions of this camera.

¥Keep the lens surface clean, since if it is contaminated with dirt or fingerprints the picture quality suffers.

When Using Auto Iris Lens

1. Strip the insulation of the auto iris lens cable 8mm from the end.

approx. 8mm

2. Strip the insulation of the core of the auto iris lens cable to expose a 2mm length.

approx. 2mm

COLOR CCD CAMERA 14 User’s Manual

COLOR CCD CAMERA 15 User’s Manual

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Ultimate Sensitivity SHC-745 Series Contents Features Do not install in high humidity environment Do not install under unstableLighting conditions May damage the CCDFront View Components and AccessoriesOverview Side View Bottom View Installation Procedures When Using Auto Iris LensRear View LensWhen Using C/CS Mount Lens Pin 1 Red Power Pin 1 Damping Pin 2 NCWhen Using a CS Mount Lens For a Video Drive LensConnecting a Monitor When Using a C Mount LensConnecting Power For AC / DC powerYou can connect power as shown in the following figure Use AC230V, 50Hz power source For SHC-745PHFunction Menu Structure How to Use the CameraHow to Set up the Functions Using this function, you can control screen brightness LensDC/Video Select Auto Iris Lens Manual Select Manual LensExposure Manual You can control shutter speed manuallyUse the White Balance function to adjust the screen color Select a desired mode using the Up and Down buttonsWhite Balance White Bal BacklightSsnr HLC High Light CompensationDAY In normal daylight conditions, the HLC is not activated OFF Not being usedButton DAY/NIGHTYou can display pictures in color or black and white Image ADJ Set it to ‘ON’ by using the Left and Right buttons SpecialPress the SET button You can enter up to 15 lettersMotion DET Privacy Hide an area you want to hide on the screenComm ADJ Communication Adjustment ExitTroubleshooting Specifications SHC-745PHMemo
Top Page Image Contents