Sony 560TVL When Using C/CS Mount Lens, For a Video Drive Lens, When Using a CS Mount Lens

Page 9

Installation Procedures

3.Remove the cover of the auto iris lens connector plug and solder the lens cable to the connector pin of the plug.

• For a Video Drive Lens

• For a DC Drive Lens

Pin 1: Red (Power)

Pin 1: Damping -

Pin 2: NC

Pin 2: Damping +

Pin 3: White (Video Signal)

Pin 3: Drive +

Pin 4: Black (Ground)

Pin 4: Drive -

 

Lens cable

No. 3 Pin

connector

No. 1 Pin

 

No. 4 Pin

 

No. 2 Pin

 

4. Fit the cover of the auto iris lens connector plug, remove the protective glass cover from the front of the camera, and fasten the auto iris lens by turning it clockwise.

5. Set focus of camera using Back Focus Control Lever of camera side after combining Auto Iris lens.

Back Focus Control Lever

When Using C/CS Mount Lens

Before installing a lens, identify whether the lens to be installed is a C-Mount or CS-Mount. This camera is set for a CS-Mount Lens by default. To install a C-Mount Lens, a simple modification is required.

When Using a CS Mount Lens

Remove the protective glass cover at the front of this product and turn the CS- Mount Lens clockwise to install it. And set focus of camera using Back Focus Control Lever of camera side after combining CS-Mount lens.

Notes

¥Use the lens connector shown in the following figure. If the dimensions of the connector are not correct, it may damage the camera, or the lens may not be installed firmly.

C-Mount Lens: 10mm or less

CS-Mount Lens: 5mm or less

¥If the lens is too heavy, the camera becomes unbalanced and there may be problems. Use a lens that weighs less than 450g.

¥When adjusting the Automatic Level Control (ALC) of an auto iris lens, use Av mode if available. If you use the Pk mode, the picture brightness may change continuously.

COLOR CCD CAMERA 16 User’s Manual

COLOR CCD CAMERA 17 User’s Manual

Image 9
Contents Ultimate Sensitivity SHC-745 Series Contents Features Do not install under unstable Do not install in high humidity environmentLighting conditions May damage the CCDComponents and Accessories OverviewFront View Side View Bottom View When Using Auto Iris Lens Installation ProceduresRear View LensPin 1 Red Power Pin 1 Damping Pin 2 NC When Using C/CS Mount LensWhen Using a CS Mount Lens For a Video Drive LensWhen Using a C Mount Lens Connecting a MonitorFor AC / DC power Connecting PowerYou can connect power as shown in the following figure Use AC230V, 50Hz power source For SHC-745PHHow to Use the Camera How to Set up the FunctionsFunction Menu Structure Lens Using this function, you can control screen brightnessDC/Video Select Auto Iris Lens Manual Select Manual LensManual You can control shutter speed manually ExposureSelect a desired mode using the Up and Down buttons Use the White Balance function to adjust the screen colorWhite Balance White Bal BacklightHLC High Light Compensation SsnrDAY In normal daylight conditions, the HLC is not activated OFF Not being usedDAY/NIGHT You can display pictures in color or black and whiteButton Image ADJ Special Set it to ‘ON’ by using the Left and Right buttonsPress the SET button You can enter up to 15 lettersPrivacy Hide an area you want to hide on the screen Motion DETExit Comm ADJ Communication AdjustmentTroubleshooting SHC-745PH SpecificationsMemo