Sony MPK-TRV2 When the Leak lamp flashes, To attach/detach the lid of the video cable connector

Page 14

Recording

To attach/detach the lid of the video cable connector

A video cable connector is provided so that video equipment can be connected to the marine pack in the future.

When you reattach the lid, grease the O-ring of the lid before inserting it into the connector.

To detach

To attach

O-ring

	1 While		1 While
2 pull out.	1 While	2 press in.	pressing
	pressing		here,
	here,
	here,

Note

Do not remove the lid underwater.

When the LEAK lamp flashes

If water happens to leak in, the LEAK lamp (yellow) flashes.

In such a case, remove the marine pack from the water as soon as possible, keeping it horizontal. Be sure to surface following the safety rules for diving.

Dry the marine pack with a soft cloth and then open it. To switch off the lamp, disconnect the remote control cable.

Check the cause of the leak.

If the video camera recorder is wet, take it to the nearest Sony dealer immediately.

								Y	LO
								Y	C
		F					B			K
	O	F				D
	O	O				N
	T		C			N
	T		U			A
A	U		U	S	T	A
	U		S
			S

O	F
	N / O
	F	REC LEAK
		REC LEAK

LEAK lamp (yellow)

14

Sony MPK-TRV2 (EN,F) 3-859-264-1X

Image 14

Contents Marine Pack Table of contents Features Supplied accessories Precautions Labeling the parts and controls Rear shell Front shellAdaptor B Position of the adaptor and the remote control cableAdaptor a CCD Grease the O-ring Check that there are no scratches or cracksRemove any dust, sand or hair from the O-ring Do not twist the O-ringWhen using adaptor A, attach it to the video camera recorder Adjust the video camera recorderWhen using adaptor a When using adaptor B Fasten the video camera recorder with Accessory belt Raise the buckles until they stop Now you are ready for underwater recording Attach the front shell to the rear shellTo keep a subject in focus RecordingTo zoom To stop recordingTo detach To attach When the Leak lamp flashesTo attach/detach the lid of the video cable connector Takeshell. the video camera recorder out of the front Remove the accessories Open the marine packRemoving the video camera recorder Remove the adaptorUnderwater recording Checkpoints SpecificationsML20, HVL-80DA CCD-TR710 Tables des matières Caractéristiques218 CCD-TR910Accessoires fournis 193Précautions 420Partie arrière Nomenclature215 Partie avantAdaptateur B 226Adaptateur a 237 RemarquesRemarques sur le joint torique 248Voir page suivante Fixation du camescope dans le Marine Pack259 Effectuer les réglages sur le camescopeQuand l’adaptateur B est utilisé 2610Quand l’adaptateur a est utilisé Fixer le camescope dans le Marine PackRelever complètement les boucles Accessoires2711 2812 Fixer la partie avant sur la partie arrièreVariation de focale Enregistrement2913 Verrouillage de la mise au pointInsertion et retrait du cache-connecteur de câble vidéo Si le témoin Leak clignote3014 RetraitInsertion3115 Enlever les accessoires Ouvrir le Marine PackRetrait du camescope Sortir le camescope de la partie avantEnregistrement sous-marin 3216Poste Points à vérifier Spécifications1733 Sony MPK-TRV2 EN,F Sony MPK-TRV2 EN,F Sony MPK-TRV2 EN,F