Introduction
Installation
How to Use
Definitions | Configuration |
Appendix
NOTES ON USE AND INSTALLATION
•Do not aim the camera at the sun
Never aim the camera at the sun even with the camera power off.
•Do not shoot intense light
Intense light such as a spotlight may cause a bloom or smear. A vertical stripe may appear on the screen. However, this is not a malfunction.
•Treat the camera with care
Dropping or subjecting the camera to intense vibration may cause it to malfunction.
•Never touch internal parts
Do not touch the internal parts of the camera other than the parts specified.
•Do not submerge in water
The camera has some protection to water (see IP rating), and can be used indoors or outdoors.
If the camera was submerged in water, turn off the power and contact your dealer.
•Keep the camera installation away from video noise
If cables are wired near electric lighting wires or a TV set, noise may appear in images. In this event relocate cables or reinstall equipment.
•Check the ambient temperature and humidity
Avoid using the camera where the temperature is hotter or colder than the specified operating range. Doing so could affect the internal parts or cause the image quality to deteriorate. Special care is required to use the camera at high temperature and humidity.
•Should you notice any trouble
If any trouble occurs while you are using the camera, turn off the power and contact your dealer. If you continue to use the camera when there is something wrong with it, the trouble may get worse and an unpredictable problem may occur.
㪊㪈㩷㪆㩷㪈㪍㪇
6