Network
This section explains how to configure wired network connection for the Network Camera. It consists the following five segments: Network Type, HTTP, Two way audio, FTP and RTSP Streaming. After completing the settings on this page, click Save to take effect.
Network Type
LAN
Select this option when the Network Camera is deployed in a local area network (LAN) and is intended to be accessed by local computers.
Get IP address automatically: Select this option to obtain a dynamic IP address assigned by a DHCP server each time the camera is connected to the LAN.
Use fixed IP address: Select this option to manually assign a static IP address to the Network Camera. Please refer to Internet connection with static IP on page 16 for details.
Enable UPnP presentation: Select this option to enable UPnPTM presentation for your Network Camera so that whenever a Network Camera is presented to the LAN, shortcuts of connected Network Cameras will be listed in My Network Places. Currently, UPnPTM is supported by Windows XP or later. To use this feature, verify that the UPnPTM component is installed on your computer.
Enable UPnP port forwarding: To access the Network Camera from the Internet, select this option to allow the Network Camera to open ports on the gateway automatically so that video streams can be sent out from a LAN. To utilize of this feature, verify that your gateway supports UPnPTM and activated.
㪍㪇㩷㪆㩷㪈㪍㪇
Introduction
Installation
How to Use
Definitions | Configuration |
Appendix
35