Introduction
Installation
How to Use
Definitions | Configuration |
Appendix
Installation (Cont.)
2.In this case, if the Local Area Network (LAN) IP address of your Network Camera is 192.168.0.3, please forward the following ports for the Network Camera on the gateway.
■HTTP port
■RTSP port
■RTP port for audio
■RTCP port for audio
■RTP port for video
■RTCP port for video
If you have changed the port numbers on the Network page, please open the ports accordingly on your gateway. For information on how to forward ports on the gateway, please refer to the gateway user's manual.
3.Find out the public IP address of your gateway provided by your ISP (Internet Service Provider). Use the public IP and the secondary HTTP port to access the Network Camera from the Internet. Please refer to Network Type on page 35 for details.
Internet connection with static IP
Choose this connection type if you are required to use a static IP for the Network Camera and follow the steps below.
1.Set up the Network Camera in a LAN. Please refer to Software installation on page 18 for details.
2.Go to Configuration > Network > Network Type. Select LAN > Use fixed IP address.
3.Enter the static IP, Subnet mask, Default gateway, Primary DNS provided by your ISP.
Internet connection via PPPoE (Point-to-Point over Ethernet)
Choose this connection type if you are connected to the Internet via a DSL Line. Please refer to PPPoE on page 36 for details.
㪋㪈㩷㪆㩷㪈㪍㪇
16