Introduction
Installation
How to Use
Definitions | Configuration |
Appendix
Configuration Definitions (Cont.)
System log
This section explains how to configure the Network Camera to send the system log message to a remote server and how to refer the current log message of the Network Camera.
It is composed of the following two Segments: Remote Log and Current Log.
Remote Log
You can configure the Network Camera to send the system log file to a remote server as a log message.
When using this feature, the appropriate syslog server is required for receiving the system log message from the Network Camera.
Follow the steps below to set up the remote log:
1.In the IP address text box, enter the IP address of the remote server.
2.In the port text box, enter the port number of the remote server.
3.When completed, select Enable remote log and click Save to take effect.
Current Log
This column displays the system's log in chronological order. The system log is stored in the Network Camera's buffer area and will be overwritten when reaching a certain amount.
The system log messages stored in the Network Camera will be all cleared after reboot or power down the Network Camera.
View parameters
The View parameters page lists the entire system's parameters in alphabetical order. If you need technical assistance, please provide the information listed in this page.
㪐㪈㩷㪆㩷㪈㪍㪇
66