|
|
|
| AUTO SETUP |
6 Press |
|
|
| MOUNTING (Mounting) |
/ | / / | to select and configure | Use to select the mounted position of the unit in your | |
each parameter and then press ENTER. | listening room. | |||
|
|
|
| Choices: SHELF (Shelf mount), WALL (Wall mount) |
|
| ENTER |
| |
|
|
|
| SHELF |
INSTALLING (Installing) |
|
| ||
Use to select the installed position of the unit in your |
| |||
listening room. |
|
|
|
|
Choices: Parallel to Wall (Parallel with wall |
| |||
installation), |
|
| ||
Angle to Wall or corner (Corner installation) | WALL | |||
Angle to Wall or corner | Parallel to Wall |
| ||
•Select Angle to Wall or corner if the unit is installed in the corner. The beam mode is set to ST+3BEAM (see page 43).
•Select Parallel to Wall if the unit is installed in parallel with the wall. The beam mode is set to 5BEAM (see page 43).
•Select WALL if the unit is mounted on the wall.
•Select SHELF if the unit is mounted on the shelf.
REFLECTING (Reflecting)
Use to select the reflectivity of your listening room. Choices: NORMAL (Normal), HI ECHO (High echo)
•Select NORMAL if your listening room has a normal reflectivity.
•Select HI ECHO if your listening room has highly reflective surfaces such as concrete walls.
7Check the following points once again before starting the AUTO SETUP procedure.
•Is the optimizer microphone firmly connected to this unit?
•Is the optimizer microphone placed in a proper location?
•Are there any large obstacles in between the optimizer microphone and the walls in your listening room?
SETUP
English
33