Yamaha YSP-1000 owner manual Beam Mode

BEAM MODE

You can change the beam mode to suit the input source of this unit using the beam mode buttons on the remote control (STEREO, 3BEAM, 5BEAM, ST+3BEAM or TARGET). Select stereo mode for 2-channel sources, 3 beam mode, 5 beam mode and stereo plus 3 beam mode for 5.1-channel playback.

All the beam modes are available in the following cases:

•If you selected Parallel to Wall for INSTALLING in AUTO SETUP (see page 33)

•If you selected settings other than CORNER RIGHT or CORNER LEFT for INSTALLED POSITION in BASIC SETUP (see page 64)

•If you selected FLAT TO WALL for INSTALLED POSITION in MANUAL SETUP (see page 70)

Only stereo, stereo plus 3 beam and target modes are available in the following cases:

•If you selected Angle to Wall or corner for INSTALLING in AUTO SETUP (see page 33)

•If you selected CORNER RIGHT or CORNER LEFT for INSTALLED POSITION in BASIC SETUP (see page 64)

•If you selected ANGLE TO WALL OR CORNER for INSTALLED POSITION in MANUAL SETUP (see page 70)

	AUTO SETUP		BASIC SETUP		MANUAL SETUP
	INSTALLING		INSTALLED POSITION		INSTALLED POSITION
	(see page 33)		(see page 64)		(see page 70)
Beam
			CORNER
mode
	Parallel to	Angle to Wall	RIGHT		FLAT TO	ANGLE TO
			or	Other settings		WALL OR
	Wall	or corner			WALL
			CORNER			CORNER
			LEFT
STEREO	Yes	Yes	Yes	Yes	Yes	Yes
3BEAM	Yes	No	No	Yes	Yes	No
5BEAM	Yes	No	No	Yes	Yes	No
ST+3BEAM	Yes	Yes	Yes	Yes	Yes	Yes
TARGET	Yes	Yes	Yes	Yes	Yes	Yes

Note

Yes: the corresponding beam mode is available.

No: the corresponding beam mode is not available.

42