Yamaha YSP-1000 owner manual Bbeam Adjustment, Beam Adjustment Beam adjustment

•Select ANGLE TO WALL OR CORNER if this unit is installed in the corner in your listening room. Adjust the width and length of your listening room as well as the distance of the listening position from this unit and the distance of the center of this unit from the left wall.

Listening position from the unit

Room width

Room length

Choices for the room width and length: 2.0 m to 12.0 m

Choices for the listening position from this unit: 2.0 m to 9.0 m

Choices for the listening position from the left wall: 0.6 m to 11.4 m

A)SETTING PARAMETERS 2/3
Room width and length		12.0m
	12.0m
[p	p	p	p
	[ENTER]:Return

A)SETTING PARAMETERS 3/3

Listening position from the
unit and the left wall	12.0m

[p	p	p	p
	[ENTER]:Return

Note

When you set the INSTALLED POSITION parameter in BASIC SETUP (see page 64) or MANUAL SETUP (see page 70), the parameters newly set for the width and length of your listening room are automatically set as the factory default value.

MANUAL SETUP

INSTALLED HEIGHT (Installed height of this unit)

Use to adjust the installed height of this unit. Control range: 0.0 m to 3.0 m

Initial setting: 1.0 m

Floor 0.0 m to 3.0 m

■BEAM ADJUSTMENT (Beam adjustment)

Use to manually adjust the various speaker beam angles. We recommend that you select 5 beam mode before adjusting these parameters.

Notes

•When INSTALLED POSITION is adjusted in BASIC SETUP (see page 64) or MANUAL SETUP (see page 70), the factory default value is automatically set for this parameter except when FOCAL LENGTH is set to CENTER (see page 73).

•Depending on the beam mode settings (see page 42), some speaker positions may not be available for selection. In this case, “– –” is displayed. When using the stereo plus 3 beam mode, set the surround left and right signals to be output from the front left and right speakers.

B)BEAM ADJUSTMENT

.

b)VERTICAL ANGLE

p p

OPERATION ADVANCED

English

71